Search

A one minimum only decoder for Trellis-EMS (OMO T-EMS) and for Trellis-Min-max (OMO T-MM) is proposed in this paper. In this novel approach, we avoid computing the second minimum in messages of the check node processor, and propose efficient estimators to infer the second minimum value. By doing so, we greatly reduce the complexity and at the same time improve latency and throughput of the derived architectures compared to the existing implementations of EMS and Min-max decoders. This solution has been applied to various NB-LDPC codes constructed over different Galois fields and with different degree distributions showing in all cases negligible performance loss compared to the ideal EMS and Min-max algorithms. In addition, two complete decoders for OMO T-EMS and OMO T-MM were implemented for the (837,726) NB-LDPC code over GF(32) for comparison proposals. A 90 nm CMOS process was applied, achieving a throughput of 711 Mbps and 818 Mbps respectively at a clock frequency of 250 MHz, with an area of 19.02 mm^2 and 16.10 mm^2 after place and route. To the best knowledge of the authors, the proposed decoders have higher throughput and area-time efficiency than any other solution for high-rate NB-LDPC codes with high Galois field order. [ABSTRACT FROM AUTHOR]

This paper proposes a low-complexity min-sum algorithm for decoding low-density parity-check codes. It is an improved version of the single-minimum algorithm where the two-minimum calculation is replaced by one minimum calculation and a second minimum emulation. In the proposed one, variable correction factors that depend on the iteration number are introduced and the second minimum emulation is simplified, reducing by this way the decoder complexity. This proposal improves the performance of the single-minimum algorithm, approaching to the normalized min-sum performance in the water-fall region. Also, the error-floor region is analyzed for the code of the IEEE 802.3an standard showing that the trapping sets are decoded due to a slow down of the convergence of the algorithm. An error-floor free operation below BER=10-15 is shown for this code by means of a field-programmable gate array (FPGA)-based hardware emulator. A layered decoder is implemented in a 90-nm CMOS technology achieving 12.8 Gbps with an area of 3.84 mm2. [ABSTRACT FROM AUTHOR]