1. Influence of Annealing on Gas-Sensing Properties of TiOx Coatings Prepared by Gas Impulse Magnetron Sputtering with Various O2 Content
- Author
-
Damian Wojcieszak, Paulina Kapuścik, and Wojciech Kijaszek
- Subjects
gas-sensing ,n or p type of sensor response ,amorphous film ,TiOx coating ,gas impulse magnetron sputtering ,annealing ,Technology ,Engineering (General). Civil engineering (General) ,TA1-2040 ,Biology (General) ,QH301-705.5 ,Physics ,QC1-999 ,Chemistry ,QD1-999 - Abstract
TiOx films were prepared by gas impulse magnetron sputtering under oxygen-deficient (ODC) and oxygen-rich conditions (ORC) and annealing at 100–800 °C was used. The O2 content had an effect on their transparency level (Tλ). The films from the ORC mode had ca. Tλ = 60%, which decreased slightly in the VIS range after annealing. The film from the ODC mode had lower transmission (ca. gopt) and Urbach energy (Eu) were also observed. The deposition parameters had an influence on the microstructure of TiOx coatings. The ORC and ODC modes resulted in columnar and grainy structures, respectively. Directly after deposition, both coatings were amorphous according to the GIXRD results. In the case of TiOxORC films, this state was retained even after annealing, while for TiOxODC, the crystalline forms of Ti and TiO2-anatase were revealed with increasing temperature. Sensor studies have shown that the response to H2 in the coating deposited under oxygen-rich conditions was characteristic of n-type conductivity, while oxygen-deficient conditions led to a p-type response. The highest sensor responses were achieved for TiOxODC annealed at 300 °C and 400 °C. more...
- Published
- 2023
- Full Text
- View/download PDF