Search

We have investigated the interactions between cationic poly(amidoamine) (PAMAM) dendrimers of generation 4 (G4), a potential gene transfection vector, with net-anionic model biomembranes composed of different ratios of zwitterionic phosphocholine (PC) and anionic phospho-L-serine (PS) phospholipids. Two types of model membranes were used: solid-supported bilayers, prepared with lipids carrying palmitoyl-oleoyl (PO) and diphytanoyl (DPh) acyl chains, and free-standing bilayers, formed at the interface between two aqueous droplets in oil (droplet interface bilayers, DIBs) using the DPh-based lipids. G4 dendrimers were found to translocate through POPC:POPS bilayers deposited on silica surfaces. The charge density of the bilayer affects translocation, which is reduced when the ionic strength increases. This shows that the dendrimer-bilayer interactions are largely controlled by their electrostatic attraction. The structure of the solid-supported bilayers remains intact upon translocation of the dendrimer. However, the amount of lipids in the bilayer decreases and dendrimer/lipid aggregates are formed in bulk solution, which can be deposited on the interfacial layers upon dilution of the system with dendrimer-free solvent. Electrophysiology measurements on DIBs confirm that G4 dendrimers cross the lipid membranes containing PS, which then become more permeable to ions. The obtained results have implications for PAMAM dendrimers as delivery vehicles to cells.

Water-soluble aggregates based on two polyion-surfactant ion "complex salts", consisting of hexadecyltrimethylammonium (C16TA(+)) and polyacrylate (PA(-)) with either 25 or 6000 repeating units, with added nonionic surfactant octaethylene glycol monododecyl ether (C12E8) have been investigated. A previous phase study has shown that added C12E5 or C12E8 can solubilize complex salts in aqueous systems, and that increasing the poly(ethylene oxide) chain length of the nonionic surfactant and/or decreasing the polyion length favors dissolution. In this work we report on dynamic light scattering, NMR diffusometry, small-angle X-ray scattering, and isothermal titration calorimetry measurements performed to characterize the solubilized composite aggregates in dilute aqueous solution in terms of size and stoichiometry. It was found that mixed aggregates of polyacrylate, C16TA(+) ions, and C12E8, with almost constant stoichiometry, coexist with free micelles of C12E8 at all investigated mixing ratios. The length of the polyion only weakly affects the stoichiometry of the mixed aggregates while strongly affecting their size and water solubility.

The macroscopic phase behavior and other physicochemical properties of dilute aqueous mixtures of DNA and the cationic surfactant hexadecyltrimethylammounium bromide (CTAB), DNA and the polyamine spermine, or DNA, CTAB, and (2-hydroxypropyl)-β-cyclodextrin (2HPβCD) were investigated. When DNA is mixed with CTAB we found, with increasing surfactant concentration, (1) free DNA coexisting with surfactant unimers, (2) free DNA coexisting with aggregates of condensed DNA and CTAB, (3) a miscibility gap where macroscopic phase separation is observed, and (4) positively overcharged aggregates of condensed DNA and CTAB. The presence of a clear solution beyond the miscibility gap cannot be ascribed to self-screening by the charges from the DNA and/or the surfactant; instead, hydrophobic interactions among the surfactants are instrumental for the observed behavior. It is difficult to judge whether the overcharged mixed aggregates represent an equilibrium situation or not. If the excess surfactant was not initially present, but added to a preformed precipitate, redissolution was, in consistency with previous reports, not observed; thus, kinetic effects have major influence on the behavior. Mixtures of DNA and spermine also displayed a miscibility gap; however, positively overcharged aggregates were not identified, and redissolution with excess spermine can be explained by electrostatics. When 2HPβCD was added to a DNA-CTAB precipitate, redissolution was observed, and when it was added to the overcharged aggregates, the behavior was essentially a reversal of that of the DNA-CTAB system. This is attributed to an effectively quantitative formation of 1:1 2HPβCD-surfactant inclusion complexes, which results in a gradual decrease in the concentration of effectively available surfactant with increasing 2HPβCD concentration.

The effects of self-assembly on the hydrolysis kinetics of surfactants that contain ester bonds are discussed. A number of examples on how reaction rates and apparent reaction orders can be modulated by changes in the conditions, including an instance of apparent zero-order kinetics, are presented. Furthermore, it is shown that the examples on reaction kinetics display parallels and connections to important physicochemical aspects of surfactant aggregates, namely, the “reservoir function” of micelles and the fact that the headgroup region of micelles constitutes an aqueous environment largely distinct from the bulk solution. The examples presented can be used in teaching organic as well as physical chemistry. The text is written with the intention to be largely self-contained, in order to make it accessible for readers with different background experience.

Betaine esters prepared from long-chain alcohols are a class of hydrolyzable cationic surfactants that is interesting both because the compounds can be designed to give harmless products on degradation and that the hydrolysis products can induce potentially useful changes in the properties of systems where such surfactants are present. In this work, the evolution in structure of aggregates formed by oleyl betainate during hydrolysis of the compound has been investigated using (1)H NMR and cryo-transmission electron microscopy (cryo-TEM). With an increasing extent of hydrolysis, and thus an increasing fraction of oleyl alcohol in the aggregates, the aggregate structure changes in a sequence consistent with an increase in the average packing parameter of the surfactant-alcohol mixture, from spherical micelles, via wormlike micelles, to vesicles. An important result from this work is that it demonstrates a means of in situ production of small unilamellar vesicles with a rather narrow size distribution.

Self-assembly in aqueous solutions of cationic surfactants that carry thioether groups in their hydrophobic tails has been investigated. Of particular interest was the identification of possible changes in the aggregate structure due to the presence of sulfur atoms. Solutions of four different compounds [CH(3)CH(2)S(CH(2))(10)N(CH(3))(3)(+)Br(-) (2-10), CH(3)(CH(2))(5)S(CH(2))(6)N(CH(3))(3)(+)Br(-) (6-6), CH(3)(CH(2))(7)S(CH(2))(6)N(CH(3))(3)(+)Br(-) (8-6), and CH(3)(CH(2))(7)S(CH(2))(8)N(CH(3))(3)(+)Br(-) (8-8)] were characterized by (1)H NMR, (13)C NMR, NMR diffusometry, and conductivity measurements. In addition to investigating aqueous solutions containing each of the thioethers present as the sole solute, mixtures of 2-10 or 6-6 with dodecyltrimethylammonium bromide (DTAB) were studied. The addition of a sulfide group to the hydrophobic tail causes an increase in the critical micelle concentration but has a limited effect on the aggregate structure. Micelles are formed at a well-defined concentration for all of the investigated surfactants and surfactant mixtures. However, a comparison of the behavior of concentrated solutions of 8-8 to that of solutions of hexadecyltrimethylammonium bromide (CTAB) of similar concentrations suggests that the presence of a sulfur atom decreases the tendency for micellar growth. This may be a consequence of a slightly higher preference for the micellar surface of a sulfur atom as compared to that of a methylene group in a similar position, an idea that is also supported by results for the surfactant mixtures.

A procedure for the preparation of calcium alginate nanoparticles in the aqueous phase of water-in-oil (W/O) nanoemulsions was developed. The emulsions were produced from mixtures of the nonionic surfactant tetraethylene glycol monododecyl ether (C(12)E(4)), decane, and aqueous solutions of up to 2 wt % sodium alginate by means of the phase inversion temperature (PIT) emulsification method. This method allows the preparation of finely dispersed emulsions without a large input of mechanical energy. With alginate concentrations of 1-2 wt % in the aqueous phase, emulsions showed good stability against Ostwald ripening and narrow, monomodal distributions of droplets with radii100 nm. Gelation of the alginate was induced by the addition of aqueous CaCl(2) to the emulsions under stirring, and particles formed were collected using a simple procedure based on extraction of the surfactant on addition of excess oil. The final particles were characterized using cryo-transmission electron microscopy (cryo-TEM) and dynamic light scattering (DLS). They were found to be essentially spherical with a homogeneous interior, and their size was similar to that of the initial emulsion droplets. The herein presented "low-energy" method for preparation of biocompatible nanoparticles has the potential to be used in various applications, e.g., for the encapsulation of sensitive biomacromolecules.

Assemblies formed by a well-defined quality of DNA (4331 bp T7 DNA) and the small net-cationic protein lysozyme in dilute aqueous solutions have been characterized using cryo-transmission electron microscopy (cryo-TEM) and dynamic light scattering (DLS) as the main techniques. In a wide range of different DNA to lysozyme ratios in solutions of low ionic strength, dispersions of aggregates with the same general morphology and a practically constant hydrodynamic size are formed. The basic structure formed in the dispersions is that of rather flexible worm-like assemblies with a diameter of 10–20 nm, which are suggested to be made up by bundles of on the order of 10 DNA chains with an intervening matrix of lysozyme. With increased ionic strength, the worm-like appearance of the assemblies is lost and they adopt a less well-defined shape. The results suggest that the formation of the DNA–lysozyme aggregates is strongly influenced by cooperative assembly of the components and that, in addition to the electrostatic attraction between DNA and lysozyme, attractive interactions between the protein units are important in governing the behavior of the system.

Results from an experimental investigation of the phase behavior of an aqueous system of DNA from salmon testes and the protein lysozyme are presented. At very low concentrations of either or both of the macromolecular components, wormlike assemblies with a width of the order of 10 nm are formed. There are strong indications that direct interactions between the protein units are instrumental both in driving the phase separation and in controlling the morphology of the formed assemblies.

The aqueous behavior of an ester-modified cationic amphiphile with the molecular structure CH3CH2O(C=O)(CH2)(6)(C=O)O(CH2)sN+(CH3)(3)Br-, in the following referred to as A, has been investigated. Systems with A as the only solute, as well as different aqueous mixtures with conventional cationic surfactants, primarily dodecyltrimethylammonium bromide (DTAB), were included in the study. Isotropic solution samples were characterized using H-1 NMR, C-13 NMR, NMR diffusometry, and conductivity measurements, whereas liquid crystalline samples were investigated by optical polarization microscopy and small-angle X-ray diffraction. The results are compared to the behavior of the binary system of DTAB and water. A does not exhibit a typical surfactant behavior. When it is present as the only solute in a binary aqueous system, it forms neither conventional micelles nor liquid crystalline phases. However; there is clear evidence that it assembles with lower cooperativity into loose clusters at concentrations above 25-30 mM. When A is mixed with DTAB in solution, the two amphiphiles form mixed assemblies, the structure of which varies with the total amphiphile concentration. In concentrated mixtures with alkyltrimethylammonium surfactants, A can participate in hexagonal liquid crystalline phases even when it constitutes a significant fraction of the total amphiphile content.

The consequences of including amide bonds into the structure of short-chain nonionic surfactants have been studied. Of particular interest were the possible effects of the hydrogen bonding ability of the amide group on the micellar shape. The aggregate structure and hydration of two different amide-containing surfactants, C7H15CO-NH-(CH2CH2O)(4)H and C7H15CO-(NH-C3H6-CO)(2)N(CH3)(2), were investigated using NMR diffusometry (pulsed gradient spin echo NMR) as the main technique. Data from experiments on the surfactants, the hydrophobic probe molecule hexamethyldisilane (HMDS), and water were interpreted to gain information about the solution structures, and the results were compared to those on a previously studied alcohol ethoxylate surfactant of similar size, C8E4. Both of the amide-containing surfactants form small micelles within the whole investigated concentration range. At the critical micelle concentration, the aggregates are most probably spherical, and with increasing surfactant concentration there are indications of either a minor aggregate growth or agglomeration of the micelles. In addition, it was found that the presence of amide groups in the surfactant inhibits the intermicellar transport of HMDS, which occurs in the C8E4 system. From measurements on water diffusion in the three surfactant systems, it could be concluded that the surfactant hydration is higher when amide bonds are present.

Soluble aggregates formed in dilute aqueous mixtures of polyacrylate (PA), the cationic surfactant decyl betainate (DB), and the nonionic surfactant octaethylene glycol monododecyl ether (C12E8) have been characterized. The aggregates formed can be viewed as mixed micelles of DB and C12E8 with the cationic charge of DB being largely neutralized by PA condensed on the micellar surface. DB contains an ester bond that is susceptible to base-catalyzed hydrolysis under mild alkaline conditions and degradation of DB leads to a decreased attraction of PA to the mixed micelles. It is shown that (1) an increasing extent of DB hydrolysis gives a gradual increase in the fraction of PA released from the mixed aggregates to the surrounding solution, and (2) the rate of hydrolysis, and thus the rate of polymer release, can be controlled by pH. The presented principle can potentially be used in controlled release devices.