Search

Intra-operative tensioning of the posterior cruciate ligament (PCL) in total knee arthroplasty (TKA) is commonly based on the surgeon's experience, resulting in a possibly loose or overly tight PCL. To date, the consequences of different PCL tensioning scenarios for the post-operative biomechanics of the knee remain unclear. Using a comprehensive musculoskeletal modelling approach that allows predictive joint kinematic and kinetic balance, we assessed variations in the movement and loading patterns of the knee as well as changes in ligament and muscle forces during walking in response to systematic variations in the PCL reference strain. The results indicate only small differences in the tibiofemoral and patellofemoral kinematics and kinetics for scenarios involving up to 10% release of the PCL (relative to the baseline reference scenario with 2% residual strain). These observations remain valid for simulations performed with high- as well as with low-conformity implant designs. However, over-tensioning of the ligament was found to considerably overload the tibiofemoral joint, including altered contact mechanics, and may therefore shorten the implant longevity. Finally, no meaningful impact of the PCL reference strain on the muscle force patterns was observed. This study therefore favours balancing the knee with a slightly loose rather than tense PCL, if appropriate intra-operative PCL tension cannot be objectively achieved.

Implant malalignment has been reported to be a primary reason for revision total knee arthroplasty (TKA). In addition, altered muscle coordination patterns are commonly observed in TKA patients, which is thought to alter knee contact loads. A comprehensive understanding of the influence of surgical implantation and muscle recruitment strategies on joint contact mechanics is crucial to improve surgical techniques, increase implant longevity, and inform rehabilitation protocols. In this study, a detailed musculoskeletal model with a 12 degrees of freedom knee was developed to represent a TKA subject from the CAMS-Knee datasets. Using motion capture and ground reaction force data, a level walking cycle was simulated and the joint movement and loading patterns were estimated using a novel technique for concurrent optimization of muscle activations and joint kinematics. In addition, over 12'000 Monte Carlo simulations were performed to predict knee contact mechanics during walking, considering numerous combinations of implant alignment and muscle activation scenarios. Validation of our baseline simulation showed good agreement between the model kinematics and loading patterns against the in vivo data. Our analyses reveal a considerable impact of implant alignment on the joint kinematics, while variation in muscle activation strategies mainly affects knee contact loading. Moreover, our results indicate that high knee compressive forces do not necessarily originate from extreme kinematics and vice versa. This study provides an improved understanding of the complex inter-relationships between loading and movement patterns resulting from different surgical implantation and muscle coordination strategies and presents a validated framework towards population-based modelling in TKA., Competing Interests: Declaration of Competing Interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2023 The Authors. Published by Elsevier Ltd.. All rights reserved.)

Background: Improved knowledge of in vivo function of the collateral ligaments is essential for enhancing rehabilitation and guiding surgical reconstruction as well as soft-tissue balancing in total knee arthroplasty. The aim of this study was to quantify in vivo elongation patterns of the collateral ligaments throughout complete cycles of functional activities., Methods: Knee kinematics were measured using radiographic images captured with a mobile fluoroscope while healthy subjects performed level walking, downhill walking, and stair descent. The registered in vivo tibiofemoral kinematics were then used to drive subject-specific multibody knee models to track collateral ligament elongation., Results: The elongation patterns of the medial collateral ligament varied distinctly among its bundles, ranging from lengthening of the anterior fibers to shortening of the posterior bundle with increases in the knee flexion angle. The elongation patterns of the lateral collateral ligament varied considerably among subjects. It showed an average 4% shortening with increasing flexion until 60% to 70% of the gait cycle, and then recovered during the terminal-swing phase until reaching its reference length (defined at heel strike)., Conclusions: The observed nonuniform elongation of the medial collateral ligament bundles suggests that single-bundle reconstruction techniques may not fully restore healthy ligament function. Moreover, the observed ligament elongation patterns indicate greater varus than valgus laxity in the loaded knee., Clinical Relevance: Through providing key knowledge about the in vivo elongation patterns of the collateral ligaments throughout complete cycles of functional activities, this study offers in vivo evidence for benchmarking ligament reconstruction and soft-tissue balancing in total knee arthroplasty., Competing Interests: Disclosure: The experimental part of this study was partially funded by Medacta International AG and the Swiss Commission for Technology and Innovation (CTI). The Disclosure of Potential Conflicts of Interest forms are provided with the online version of the article (http://links.lww.com/JBJS/G464).

This study aimed to quantify the elongation patterns of the collateral ligaments following TKA during functional activities of daily living. Using mobile video-fluoroscopy to capture radiographic images of the knee in a group of six patients, each with an ultra-congruent knee implant, tibiofemoral kinematics were reconstructed throughout complete cycles of level gait, downhill walking, stair descent, and squat activities. Kinematic data were then used to drive subject-specific multibody knee models to estimate length-change patterns of the LCL as well as three bundles of the MCL. In addition, a sensitivity analysis examined the role of the attachment site in the elongation patterns. Our data indicate a slackening of the LCL but non-uniform length-change patterns across the MCL bundles (ranging from lengthening of the anterior fibers to shortening of the posterior fibers) with increasing knee flexion angle. Near-isometric behavior of the intermediate fibers was observed throughout the entire cycle of the studied activities. These length-change patterns were found to be largely consistent across different activities. Importantly, length-change patterns were critically sensitive to the location of the femoral attachment points relative to the femoral component. Thus, in TKA with ultra-congruent implants, implantation of the femoral component may critically govern post-operative ligament function.