Search

Metro trains often encounter the problem of wheel flange wear when they pass through sharp curves, especially for the poor wheel–rail profile matching or lack of lubrication, evidently increasing t...

High-order polygonal wear wheels have been detected on metro express train operating on one metro line in China, which cause fatigue failures of steel coil springs in the primary suspension. A seri...

Discrete irregularities are a common issue occurring on locomotive wheels. The wheel roughness measured in the field sites indicates that some wheels suffer from discrete wheel irregularities, such...

This paper presents an investigation into the mechanism of polygonal wear of metro train wheels through experiments conducted at field sites. The experiments comprise dynamic behaviour test of vehi...

Experiments were conducted at field sites to investigate the mechanism of the polygonal wear of electric locomotive wheels. The polygonal wear rule of electric locomotive wheels was obtained. Moreover, two on-track tests have been carried out to investigate the vibration characteristics of the electric locomotive's key components. The measurement results of wheels out-of-round show that most electric locomotive wheels exhibit polygonal wear. The main centre wavelength in the 1/3 octave bands is 200 mm and/or 160 mm. The test results of vibration characteristics indicate that the dominating frequency of the vertical acceleration measured on the axle box is approximately equal to the passing frequency of a polygonal wheel, and does not vary with the locomotive speed during the acceleration course. The wheelset modal analysis using the finite element method (FEM) indicates that the first bending resonant frequency of the wheelset is quite close to the main vibration frequency of the axle box. The FEM...

This paper presents a detailed investigation of out-of-round electric locomotive wheels through extensive measurement conducted at field sites. More than 2000 wheels, of seven types of locomotives widely used in China, have been measured since April 2013. The measurement results indicate that two types of freight traffic locomotives suffer serious polygonal wear problems with center wavelengths ranging from 160 to 315 mm. The dominating wavelength is 200 mm. Therefore, the investigations are mainly focused on the two locomotive types. The other types, which are taken for comparison, do not exhibit obvious polygonal wear. However, they exhibited more or less eccentricity. The effect of wheel re-profiling on the wheel polygon is also investigated and discussed. The dominating harmonic orders and center wavelengths after re-profiling are consistent with those before re-profiling at the correct circumstances, if the center wavelength of the polygonal wear is about 200 mm.