Search

The bacterial reaction of ammonium oxidation coupling with iron reduction (Feammox) has been discovered recently. To improve the ammonium removal efficiency from wastewater of Feammox bacteria, magnetic chitosan hydrogel beads (MCHBs) were prepared via sodium hydroxide co-precipitating-sol-gel method, Feammox bacteria were immobilized to 1-5 mm MCHBs, and the ammonium removal efficiency by MCHBs-Feammox bacteria was compared to free-Feammox bacteria. In addition, the influences of initial ammonium concentration, pH and temperature were assessed. The results showed that the MCHBs were ferromagnetic and exhibited high crystallinity, with the magnetization of saturation of 29.46 emu·g -1 . The average rates of ammonia oxidation and iron reduction increased by 42.96% and 20.75% after Feammox bacteria immobilization, respectively, and the most significant effect was observed on 1-2 mm MCHBs-Feammox bacteria ( P <0.05). Furthermore, 1-2 mm MCHBs immobilized bacteria worked in less favorable matrix concentrations, temperatures, and pH. Particularly, it could maintain high ammonium removal efficiency with 60.00 mg·L -1 initial ammonium concentration, 25℃ temperature and 4.50 pH. In addition, nitrate and ferrous ions were detected in the system. The highest ammonium removal rate occurred on day 16, reaching 53.62%. These results indicated that MCHBs immobilization can improve the ammonium removal efficiency of Feammox.

Soluble microbial products (SMP) are the major component of the residual organic fraction in biological wastewater treatment effluent. The impact of process parameters on SMP production by specific groups of bacteria is currently unknown. In this work, SMP production by activated sludge at different substrate concentrations, dissolved oxygen (DO) levels and temperatures, was evaluated by experimental and modeling approaches. The results showed that among the three parameters, SMP production was most sensitive to substrate concentration. Total SMP production was increased 70.5% by a threefold increase in substrate concentration, with SMP produced from heterotrophs, ammonia-oxidizing bacteria (AOB) and nitrite-oxidizing bacteria (NOB) increasing by 61.2%, 580.0% and 410.0%, respectively. The effect of temperature on SMP was less pronounced. Decreasing the temperature from 20 °C to 10 °C decreased total SMP by 17.2%, with SMP production from heterotrophs decreasing by 20.0%, and from the AOB and NOB increasing by 180.0% and 140.0%. DO concentration had nearly no effect on total and heterotrophic SMP production, while it did have a significant positive effect on autotrophic SMP production. SMP production from AOB and NOB decreased by 24.3% and 47.8%, respectively following a decrease in DO concentration from 8.7 to 1.5 mg/L. However, the net effect of DO on total SMP production was negligible., (Copyright © 2012 Elsevier Ltd. All rights reserved.)

Soluble microbial products (SMP) generated by microbial populations can adversely affect the efficiency of biological wastewater treatment systems and secondary effluent quality. In this work, both experimental and modeling approaches were used to investigate the formation of SMP by both heterotrophic and autotrophic bacteria. Strategies to control and reduce SMP in activated sludge systems were thus evaluated. SMP produced by heterotrophs were found to account for more than 92% of total SMP. The SMP produced by autotrophs contributed to less than 8% of the total SMP, with 5% attributable to the ammonia-oxidizing bacteria (AOB) and 3% to the nitrite-oxidizing bacteria (NOB). When external organic substrate was present, the utilization-associated products (UAP) were the main component of SMP. When external organic substrate was completely consumed, biomass-associated products (BAP) from the hydrolysis of extracellular polymeric substances (EPS) dominated the SMP. The model developed in this study described the fractions and dynamics of UAP and BAP produced by heterotrophs, AOB and NOB. Solids retention time of the reactor had a significant effect on SMP production, while the effect of the hydraulic retention time was only minor. Decreasing the solids retention time from 15 to 0.5 d reduced SMP production in the reactor by 62%., (Copyright © 2012 Elsevier Ltd. All rights reserved.)

In this work, nitrogen loss in the nitrite oxidation step of the nitrification process in an aerobic-granule-based reactor was characterized with both experimental and modeling approaches. Experimental results showed that soluble microbial products (SMP) were released from the nitrite-oxidizing granules and were utilized as a carbon source by the heterotrophs for denitrification. This was verified by the fluorescence in situ hybridization (FISH) analysis. Microelectrode tests showed that oxygen diffusion limitation did result in an anoxic micro-zone in the granules and allowed sequential utilization of nitrate as an electron acceptor for heterotrophic denitrification with SMP as a carbon source. To further elucidate the nitrogen loss mechanisms, a mathematic model was formulated to describe the growth of nitrite oxidizers, the formation and consumption of SMP, the anoxic heterotrophic growth on SMP and nitrate, as well as the oxygen transfer and the substrate diffusion in the granules. The results clearly indicate that the heterotrophs grown on the SMP released by the autotrophs are responsible for the nitrogen loss in the nitrifying granules, and give us a better understanding of the aerobic granules for nitrogen removal. Biotechnol. Bioeng. 2011;108: 2844-2852. © 2011 Wiley Periodicals, Inc., (Copyright © 2011 Wiley Periodicals, Inc.)

In this work, the heterotrophic growth on the microbial products of autotrophs and the effecting factors were evaluated with both experimental and modeling approaches. Fluorescence in situ hybridization (FISH) analysis illustrated that ammonia oxidizers (AOB), nitrite oxidizers (NOB), and heterotrophs accounted for about 65%, 20%, and 15% of the total bacteria, respectively. The mathematical evaluation of experimental data reported in literature indicated that heterotrophic growth in nitrifying biofilm (30-50%) and granules (30%) was significantly higher than that of nitrifying sludge (15%). It was found that low influent ammonium resulted in a lower availability of soluble microbial products (SMP) and a slower heterotrophic growth, but high ammonium (>150 mg N L(-1)) feeding would lead to purely AOB dominated sludge with high biomass-associated products contained effluent, although the absolute heterotrophic growth increased. Meanwhile, the total active biomass concentration increased gradually with the increasing solids retention time, whereas the factions of active AOB, NOB, and heterotrophs varied a lot at different solids retention times. This work could be useful for better understanding of the autotrophic wastewater treatment systems., (Copyright © 2010 Wiley Periodicals, Inc.)

In this work, both experimental and modeling approaches are used to explore the formation of soluble microbial products (SMP) by activated sludge under anoxic conditions. With substrate consumption, the SMP concentration increases gradually. Utilization associated products (UAP) are the main fraction of SMP when substrate is present; whereas biomass associated products (BAP) are the major content of SMP as substrate is completely consumed. The fraction of the accumulated SMP accounts for 3-4% of initial organic substrate. Three dimensional excitation emission matrix analysis results indicate that the SMP concentration increases in the denitrification process. The accumulation of nitrite up to 22.6 mg/l under anoxic conditions has no significant effect on the SMP formation. With a consideration of SMP formation under anoxic conditions, an ASM3-based denitrification model is developed. The results show that the developed model is able to capture the relationship between the SMP formation and the substrate consumption by activated sludge in the denitrification process.

Anaerobic ammonium oxidation (anammox) is a promising new process to treat high-strength nitrogenous wastewater. Due to the low growth rate of anaerobic ammonium-oxidizing bacteria, efficient biomass retention is essential for reactor operation. Therefore, we studied the settling ability and community composition of the anaerobic ammonium-oxidizing granules, which were cultivated in an upflow anaerobic sludge blanket (UASB) reactor seeded with aerobic granules. With this seed, the start-up period was less than 160 days at a NH(4)(+)-N removal efficiency of 94% and a loading rate of 0.064 kg N per kg volatile suspended solids per day. The formed granules were bright red and had a high settling velocity (41 to 79 m h(-1)). Cells and extracellular polymeric substances were evenly distributed over the anaerobic ammonium-oxidizing granules. The high percentage of anaerobic ammonium-oxidizing bacteria in the granules could be visualized by fluorescent in situ hybridization and electron microscopy. The copy numbers of 16S rRNA genes of anaerobic ammonium-oxidizing bacteria in the granules were determined to be 4.6 x 10(8) copies ml(-1). The results of this study could be used for a better design, shorter start-up time, and more stable operation of anammox systems for the treatment of nitrogen-rich wastewaters.

In this work the extracellular polymeric substances (EPS) produced by mixed microbial community in activated sludge are characterized using gel-permeating chromatography (GPC), 3-dimensional excitation-emission matrix (EEM) fluorescence spectroscopy measurement and mathematical modeling. Chromatograms of extracted EPS exhibit seven peaks, among which proteins have four peaks and polysaccharides have three peaks. Evolution of the chromatogram area indicates that the quantity of produced EPS increases significantly in the substrate utilization process. With the parallel factor analysis (PARAFAC) approach, two components of the polymer matrix are identified by the EEM analysis, one as EPS proteins at Ex/Em 280/340 nm and one matrix associated as fulvic-acid-like substances at 320/400 nm. The proteins and fulvic-acid-like substances in the EPS increase in the substrate utilization phase, but decrease in the endogenous phase. To have a better insight into EPS production, the kinetic modeling of EPS is performed with regard to their molecular weight distribution and chemical natures identified by GPC and EEM. In this way, the dynamics of these important microbial products are better understood.

The autotrophs in activated sludge play an important role in biological wastewater treatment, especially in the nitrification process. Compared with the heterotrophs in activated sludge, information about the growth, maintenance, and product formation of the autotrophs is still sparse. In this work both experimental and modeling approaches are used to investigate the growth, nitrite inhibition, maintenance, and formation of extracellular polymeric substances (EPS) and soluble microbial products (SMP) of the autotrophs, with nitrite-oxidizing bacteria (NOB) in activated sludge as an example. The unified theory for EPS and SMP is integrated into our model to describe the microbial product formation of the NOB. Extensive experiments were carried out using the NOB-enriched in a sequencing batch reactor for the calibration and validation of the developed model. Results show that the NOB spend a considerable amount of energy on maintenance processes. Their apparent growth yield is estimated to be 0.044 mg COD biomass mg(-1)N. The model simulations reveal that the concentrations of EPS and SMP in the NOB-enriched culture initially increase, but later decrease gradually, and that the SMP formed in the nitrite oxidation process are biodegradable.