Search

Cytolytic toxin Cyt1A from Bacillus thuringiensis var. israelensis is used as an environmentally friendly insecticide, but its mode of action has not been clearly established. One main obstacle seems to be the lack of the experimentally determined structure of the toxin. As a first step in computer simulations of Cyt1A, in this paper, a three-dimensional molecular structure of Cyt1A in solution was generated by homology modeling, potential energy minimization and molecular dynamics. Regions of the toxin molecule that manifest increased conformational flexibility--and thus are likely to participate in the initial membrane binding and conformational changes--were then identified. Finally, the simulated structure was used to study the effect of a single amino-acid mutation that is known to abrogate the toxicity of Cyt1A in vivo.

The cytolytic delta-endotoxin Cyt1A from Bacillus thuringiensis var. israelensis is used in commercial preparations of environmentally safe insecticides. The current hypothesis on its mode of action is that the toxin self-assembles into well-defined cation-selective channels or pores, which results in colloid-osmotic lysis of the cell. Recently, a new hypothesis has been put forward suggesting that Cyt1A rather nonspecifically aggregates on the membrane surface and acts in a detergent-like manner. To distinguish between these two hypotheses, we investigated whether in the presence of lipid Cyt1A self-assembles into stoichiometric oligomers, which are characteristic of pores or channels, or aggregates into nonstoichiometric complexes, which would support the detergent-like model. Sodium dodecyl sulfate-polyacrylamide gel electrophoresis revealed that in the presence of lipid Cyt1A forms protein aggregates with a broad range of molecular weights, some being too large to enter the gel. Cyt1A tryptophan (Trp) fluorescence in the presence of lipid exhibited a decrease in anisotropy and quantum yield, but an unchanged lifetime, which is consistent with the presence of toxin aggregates in the membrane. Electrostatic interactions between the charged amino acid residues and the lipid headgroups are responsible for bringing the protein to the membrane surface, while hydrophobic and/or van der Waals interactions make the membrane binding irreversible. Fluorescence photobleaching recovery, a technique that measures the diffusion coefficient of fluorescently labeled particles, and epifluorescence microscopy revealed that upon addition of Cyt1A lipid vesicles were broken into smaller, faster diffusing objects. Since no change in size or morphology of the vesicles is expected when pores are formed in the osmotically equilibrated membranes, our results support the detergent-like mode of action of Cyt1A.

Cyt1A is a cytolytic toxin produced by Bacillus thuringiensis var. israelensis. Due to its toxicity in vivo against mosquitoes and black flies, it is used as an environmentally friendly insecticide, although its mode of action is not completely understood. The toxin is membrane-active, but its membrane-bound conformation is unknown. In the absence of direct structural data, fluorescence spectroscopy was used to obtain indirect information on Cyt1A conformation changes in the environment mimicking the vicinity of the lipid membrane (lower pH and increased ionic strength). With decreasing pH, Cyt1A's surface hydrophobicity increased, which is consistent with an increased interaction with model membranes at low pH values, as observed previously. The pK(a) value of this conformation change is 4.4+/-0.1. Intrinsic tryptophan fluorescence decreased with decreasing pH, and the pK(a) value was the same as the one determined with synthetic probes. The protein has two types of hydrophobic binding sites, and at low pH these sites bind more probe molecules (bis-ANS) with a higher affinity than at pH 7.4. When bound to the lipid, the toxin exhibited conformation similar to the molten-globule state and showed some characteristics also observed at low pH. However, the conformation of the lipid-bound toxin did not depend on pH. Neutral salts like NaCl and KCl induced conformational changes at neutral pH, but not at low pH. These changes were most probably due to specific interactions of the salt ions with the charged amino acids on the protein surface rather than due to general effects such as Hofmeister and Debye-Hückel. Our results might contribute to elucidating the mode of action of Cyt1A, and perhaps also to improving the formulation of the insecticidal preparations.

Abstract: Cyt1A is a cytolytic toxin from Bacillus thuringiensis var. israelensis. A computer model of the toxin in solution was generated and validated by resonance energy transfer (RET). The average distance between the two tryptophans (residues 158 and 161) and the fluorescently labeled cysteine 190 was 2.16 nm, which closely matched the distance predicted in computer simulations, 2.2 nm. The simulation results were able to explain two previous experimental observations: (i) amino-acid sequences of all Cyt toxins contain four blocks of highly conserved residues; and (ii) several single-point mutations drastically abrogated Cyt1A''s toxicity. Selective randomization of atomic coordinates in the computer model revealed that the conserved blocks are important for proper folding and stability of the toxin molecule. Replacing lysine 225 with alanine, a mutation that renders the toxin inactive, was shown to result in breaking the hydrogen bonds between K225 and V126, L123, and Y189. Calculated Helmholtz free energy difference of the inactive mutation K225A was higher by 12 kcal/mol and 5 kcal/mol than the values for the benign mutations K118A and K198A, respectively, which indicates that the K225A mutant is significantly destabilized. The normal-mode and principal-component analyses revealed that in the wild-type Cyt1A the region around the residue K225 is quite stationary, due to the hydrogen-bond network around K225. In contrast, pronounced twisting and stretching were observed in the mutant K225A, and the region around the residue K225 becomes unstable. Our results indicate that conformational differences in this mutant spread far away from the site of the mutation, suggesting that the mutant is inactivated due to an overall change in conformation and diminished stability rather than due to a localized alteration of a “binding” or “active” site. [Copyright &y& Elsevier]