Search

The rigid pile composite foundation is widely used in highway projects in soft soil area as it can effectively increase the bearing capacity and stability of the foundation. While the research on the behavior and failure mode of rigid pile composite foundation under embankment is not enough, instability failure of rigid pile composite foundation often occurs in practical projects. This paper presents a centrifuge model test to investigate the load transfer mechanism, settlement characteristic and failure mode of rigid pile composite foundation under embankment. The test results show that: the soil displacement of different region in rigid pile composite foundation was different, obvious vertical displacement occurred in the soil under the center of embankment and the horizontal displacement was very small in this region; both vertical and horizontal displacement occurred in the soil under the shoulder of embankment; and obvious horizontal displacement occurred in the soil under the slope toe of embankment; moreover, ground heave also occurred near the slope toe of embankment. The soil displacement in rigid pile composite foundation had a large influence on the stress characteristic and failure mode of rigid piles, the compressive failure and bending failure would probably occur for the piles under the center and shoulder of the embankment, respectively, and the tension-bending failure would probably occur for the piles under the slope toe of embankment. The different failure modes of piles at different regions should be considered in the design of rigid pile composite foundation under embankment. The test results can be used to improve the design method for rigid pile composite foundation under embankment in practical projects. [ABSTRACT FROM AUTHOR]

This paper presents the results of a series of model tests performed to study the shaft capacity of pre-bored grouted planted nodular (PGPN) pile in dense sand. The influence of the vertical overburden pressure on the shaft capacity of the PGPN pile is also investigated based on the test results. The test piles were equipped with strain gauges to measure the axial loads during the loading process, moreover, a foam plate was buried beneath pile tip to eliminate the influence of tip resistance on the shaft capacity. Some conclusions can be drawn based on the test results: the peak skin friction of PGPN pile increases with the increase of vertical overburden pressure applied on the foundation soil, while the rate of increase decreases with the increasing overburden pressure; the surface of the pile–soil interface of PGPN pile is relatively rough, and significant dilatant increase in lateral stress occurs during the loading process. [ABSTRACT FROM AUTHOR]