Search

Experimental tests of cross-laminated timber (CLT)-concrete composite floor panels were conducted. The tests consisted of linear-elastic tests of square CLT-concrete composite panels with a novel shear connector to determine elastic orthotropic plate properties. After the linear-elastic tests, the panels were subjected to a patch load at the center of the panel and tested to failure. To investigate load transfer across longitudinal joints between adjacent panels, nonuniform bending tests were conducted. Results from the experimentally measured orthotropic plate properties showed that the shear connector increased the bending stiffness in the weak direction of the panel compared to prior test results using conventional shear connectors. The tests to failure exhibited larger differences in behavior between the strong and weak orientations of the specimens, with both showing substantial inelastic behavior prior to failure. Numerical finite element models of the patch-load test showed good agreement with experimental results. Analytical formulas using the obtained orthotropic plate properties did not agree with experimental results for the patch-load at linear scales, suggesting the simplified method is currently not suited for CLT-concrete two-way bending. Load-transfer tests found that the reinforced concrete topping is capable of transferring load across the longitudinal joint of two parallel panels to enable two-way bending of composite timber–concrete floors and that the addition of a plywood spline with closely spaced screws enables a higher degree of force transfer. [ABSTRACT FROM AUTHOR]