Search

When a blasting is executed near two tunnels, the blasting wave will trigger a dynamic response and damage to the tunnels. Depending on the tunnel distribution, the path of the blasting wave to the remote non-adjacent tunnels will change. The aim of this study is to analyze the effect of the tunnel distribution on the dynamic response characteristics of a remote non-adjacent tunnel. Numerical models of two tunnels were established by PFC2D and three different tunnel distributions were considered. The two tunnels were divided into the adjacent tunnel and the non-adjacent tunnel according to their relative distance to the blasting source. The dynamic stress evolution, damage characteristics and the evolution of strain energy of the non-adjacent tunnel were initially analyzed. The results show that the stress wave amplitude of the non-adjacent tunnel is closely related to the tunnel distribution, but only near the sidewalls of the non-adjacent tunnel is the stress wave waveform sensitive to the tunnel distribution. The larger the tunnel dip, the more severe the damage to the non-adjacent tunnel. In addition, as the tunnel dip increases, the maximum strain energy densities (SEDs) in the roof, floor and sidewalls of the non-adjacent tunnel exhibit different trends. The influence of the wavelength of the blasting wave is further discussed. It is shown that the dynamic stress amplification factor and damage degree around the non-adjacent tunnel is usually positively correlated with the wavelength of the blasting wave. Moreover, the release of strain energy around the non-adjacent tunnel has a positive correlation with the wavelength. The SED variations in different areas around the non-adjacent tunnel also exhibit different trends with the increase of tunnel dip. [ABSTRACT FROM AUTHOR]

A physical model test is carried out to simulate the blasting disturbance on the underground tunnel. The test including four blasting events with different blasting locations, where two blasting angles ( α ) and two blasting distances (D) are designed. The surface deformation characteristics of the physical model are observed by a DIC system. The deformation responses of four strain components during blasting are obtained. The influences of the blasting location on the surface deformation and failure characteristics are analyzed. The distributions of strain components εx, εy, εxy, and ε1 are obtained for different blasting locations. The different occurrences of failure are compared for cases where the blasthole is at varying locations from the tunnel. The results show that when the blasthole is far from the tunnel, the failure mainly occurs in the vicinity of the blasthole and the failure pattern of the physical model is conical. When the blasthole is close enough to the tunnel and is near the vertical wall, the surrounding rock fail in a V-shape. According to the failure patterns, the anti-disturbance ability of the arch is obviously stronger than that of the vertical wall. [ABSTRACT FROM AUTHOR]