Search

Daylight redirecting systems with vertical windows have the potential to offset lighting energy use in deep perimeter zones. Microstructured prismatic window films can be manufactured using low-cost, roll-to-roll fabrication methods and adhered to the inside surface of existing windows as a retrofit measure or installed as a replacement insulating glass unit in the clerestory portion of the window wall. A clear film patterned with linear, 50-250 micrometer high, four-sided asymmetrical prisms was fabricated and installed in the south-facing, clerestory low-e, clear glazed windows of a full-scale testbed facility. Views through the film were distorted. The film was evaluated in a sunny climate over a two-year period to gauge daylighting and visual comfort performance. The daylighting aperture was small (window-towall ratio of 0.18) and the lower windows were blocked off to isolate the evaluation to the window film. Workplane illuminance measurements were made in the 4.6 m (15 ft) deep room furnished as a private office. Analysis of discomfort glare was conducted using high dynamic range imaging coupled with the evalglare software tool, which computes the daylight glare probability and other metrics used to evaluate visual discomfort.The window film was found to result in perceptible levels of discomfort glare on clear sunny days from the most conservative view point in the rear of the room looking toward the window. Daylight illuminance levels at the rear of the room were significantly increased above the reference window condition, which was defined as the same glazed clerestory window but with an interior Venetian blind (slat angle set to the cut-off angle), for the equinox to winter solstice period on clear sunny days. For partly cloudy and overcast sky conditions, daylight levels were improved slightly. To reduce glare, the daylighting film was coupled with a diffusing film in an insulating glazing unit. The diffusing film retained the directionality of the redirected light spreading it within a small range of outgoing angles. This solution was found to reduce glare to imperceptible levels while retaining for the most part the illuminance levels achieved solely by the daylighting film.

Abstract: Large-area polymer thermochromic (TC) laminated windows were evaluated in a full-scale testbed office. The TC interlayer film exhibited thermochromism through a ligand exchange process, producing a change in solar absorption primarily in the visible range while maintaining transparent, undistorted views through the material. The film had a broad switching temperature range and when combined to make an insulating window unit had center-of-glass properties of Tsol=0.12–0.03, Tvis=0.28–0.03 for a glass temperature range of 24–75°C. Field test measurements enabled characterization of switching as a function of incident solar irradiance and outdoor air temperature, illustrating how radiation influences glass temperature and thus effectively lowers the critical switching temperature of TC devices. This was further supported by EnergyPlus building energy simulations. Both empirical and simulation data were used to illustrate how the ideal critical switching temperature or temperature range for TC devices should be based on zone heat balance, not ambient air temperature. Annual energy use data are given to illustrate the energy savings potential of this type of thermochromic. Based on observations in the field, a broad switching temperature range was found to be useful in ensuring a uniform appearance when incident irradiance is non-uniform across the facade. As indicated in prior research, a high visible transmittance in both the switched and unswitched state is also desirable to enable reduction of lighting energy use and enhance indoor environmental quality. [Copyright &y& Elsevier]