Search

The relevance of the study is determined by the demand for a physically adequate mathematical description of the interactions of water in the soil to develop a model of soil moisture dynamics as the intellectual core of resource-saving technologies for precise irrigation farming. The aim of the work is theoretical substantiation and mathematical formulation of the hydrophysical functions of the soil, taking into account hysteresis. A description of three systems of soil hydrophysical functions is given. To verify and compare the systems, computational experiments were carried out using both the package of original software and “3305 Ida silt loam (> 15 cm)” soil data from the authoritative literary source – the Mualem catalogue. The parameters of the functions were identified by the method of point approximation of the experimental data on the main branches of the hysteretic water-retention capacity. Using these parameters, we calculated (i) predictive estimates for the values of the function of relative hydraulic conductivity; (ii) scanning branches of the hysteretic water-retention capacity; (iii) precise irrigation rate. The hysteresis phenomenon is not typical for the hydraulic conductivity as a function of the volumetric water content in the soil. The original functions of System 3 are recommended for use. The advantages of the proposed method for calculating the precise irrigation rate are shown. The benefit of each system is that the functions forming this system, namely the water-retention capacity and the relative hydraulic conductivity of the soil, have a common set of parameters. For the type of soil considered, in case of using the identical value of pre-irrigation soil moisture (179 [cm3 · cm-3]), both for calculating the precision irrigation rate and according to the “traditional” method, when moistening 50 cm soil layer, the total unproductive water consumption at irrigation rate 555 [m3 · ha-1] can reach 0.029 [cm3 · cm-3] or 140 [m3 · ha-1] in the calculated layer. At the same time, when applying precision standards, an excess of free moisture is not formed. It shows additional opportunities not only to save water during irrigation, especially in arid regions, but also to reduce the leaching of nutrients and agrochemicals outside the calculated soil layer and, accordingly, to reduce the additional environmental load on the surrounding area.

Data on soil moisture reserves are the basis for decision-making in the agricultural boghara system, because it determines the development of agricultural crops potential, terms of top-dressing and additional fertilizing, and makes it possible to predict yield of agricultural crops. In this article the influence of relief morphometric characteristics on the distribution of precipitation over the territory was studied. The research area is the land of the eastern part of Klepininsky rural settlement of Krasnogvardeysky district, the central part of Crimean Peninsula. The article considers approaches, divided into 2 main categories (according to the type of data used), based on the use of GIS capabilities and remote sensing data, to analyze the soil water content (SWC) using the example of research area and relationship of this parameter to the terrain relief. It was established that the morphometric characteristics of relief affect the amount of soil moisture.

Some problems of decision support systems in computer aided agriculture are discussed. The main focus is made on collaborative model development, including model decomposition issues and implementation of generic frameworks for polyvariant model use. A current state and prospective ideas for improvement of modeling infrastructure suitable to perform multi-factor computer experiments with existing crop simulation models are presented.

Typical use cases of the crop simulation models consist of such operations as parametric identification, yield forecast and optimization, analysis of different technologies etc. All these tasks relate to multiple running of the model with several variants of input parameters and can be automated by means of polyvariant crop simulation framework which allows performing the multiple running in the batch mode. Such framework has been developed in our laboratory. It makes it possible to register any crop simulation model in the database and to perform several typical operations with it. As a result we present the wide-functional computer system for planning and automation of multi-factor computer experiment with arbitrary dynamic crop models.