Search

Elucidating dissolution kinetics and mechanisms at carbonate mineral-water interfaces is essential to many environmental and geochemical processes, including geologic CO(2) sequestration in deep aquifers. In the present work, effects of background electrolytes on dolomite (CaMg(CO(3))(2)) reactivity were investigated by measuring step dissolution rates using in situ hydrothermal atomic force microscopy (HAFM) at 90 °C. Cleaved surfaces of dolomite were exposed to sodium chloride and tetramethylammonium chloride (TMACl) aqueous solutions with ionic strengths (I) ranging from 0 to 0.77 m at pH 4 and pH 9. HAFM results demonstrated that dolomite step retreat rates increased with increasing solution ionic strength and decreasing pH. Comparison of [481] and [441] steps revealed that the anisotropy of [481] and [441] step speeds became significant as solution ionic strength increased, with NaCl exerting more pronounced effects than TMACl for the same I. To interpret the different trends observed for NaCl and TMACl, a dissolution mechanism involving orientation-dependent ion adsorption and consequent edge free energy changes is proposed.

Abstract: Experimental observation of step (i.e., a linear discontinuity in a surface) growth on calcium carbonate and barium sulfate surfaces was performed using in situ scanning probe microscopy (SPM) in aqueous solutions. Step speeds at very short step lengths (<300nm) were found to increase with step length, but scatter in the data precluded comparison of different theoretical models with regard to the experimental data. Analysis of experimental errors revealed that the data scatter was not unusual and further suggested that significant experimental bias in the determination of step properties such as the step free energy and kinetics of kink propagation and nucleation are introduced if the instrument bandwidth is not appropriate for the specific dynamics of the step. In light of step growth models based on either equilibrium assumptions or non-equilibrium assumptions, these biases tend to favor one model over the other. [Copyright &y& Elsevier]

Abstract: In situ Atomic Force Microscopy (AFM) and Lateral Force Microscopy (LFM) studies on dolomite (101̄4) were performed during exposure to supersaturated aqueous solutions (supersaturated in dolomite, calcite, aragonite, vaterite, huntite and magnesite) at pH = 9 at various Ca2+/Mg2+ aqueous ion activity ratios. At high saturation ratios, rapid growth of a single layer (∼3 Å thick) of a carbonate followed by much slower growth of a second layer was observed. Growth of the second layer was highly inhibited, suggesting that the first layer was essentially self-limited, and inhibited further layer-by-layer growth. The growth of the first layer was observed over a wide range of Ca2+/Mg2+ ratios, suggesting that the dolomite surface is favorable to formation of a range of Ca-Mg carbonates. LFM data revealed contrast in the tip-surface frictional forces on the first grown layer, but this contrast was only observed in layers grown from middle to high Ca2+/Mg2+ solutions. Thus, LFM may have detected or responded to differences in the structure and/or composition between the first layer relative and the dolomite substrate. Dissolution of the first layer occurred from significantly supersaturated solutions relative to ordered stoichiometric dolomite permitting an estimate of the excess interfacial strain energy of up to 10 mJ/m2. [Copyright &y& Elsevier]