Search

Traditionally voltage control in distribution power system (DPS) is performed through voltage regulating devices (VRDs) including on load tap changers (OLTCs), step voltage regulators (SVRs), and switched capacitor banks (SCBs). The recent IEEE 1547-2018 from March 2018 requires inverter fed distributed energy resources (DERs) to contribute reactive power to support the grid voltage. To accommodate VAR from DERs, well-organized control algorithm is required to use in this mode to avoid grid oscillations and unintended switching operations of VRDs. This paper presents two voltage control strategies (i) static voltage control considering voltage-reactive power mode (IEEE 1547-2018), (ii) dynamic and extensive voltage control with maximum utilization of DER capacity and system stability. Further, effective time-graded control is implemented between VRDs and DER units to reduce the simultaneous and negative operation. The proposed voltage control strategies are tested in a realistic 140-bus southern California distribution power system through extensive time-domain simulation studies. The results show that voltage quality in a distribution system is effectively achieved through the proposed voltage control strategies with a significantly reduction in the number of switching operations of VRDs. In addition, proposed voltage control strategies increase reliability and security of the DPS during unexpected failures. [ABSTRACT FROM AUTHOR]

This paper proposes a new family of multilevel inverter topology that is able to generate seven voltage levels by utilizing one or two floating capacitors and 10 power switches. This novel boost switched-capacitor seven-level inverter possesses voltage boosting capability with an achievable maximum voltage level 1.5 times the input direct current (dc) voltage. The generation of higher output voltage does not incur high-voltage stress on any power switch in this topology, as the peak inverse voltages of all power switches do not exceed the input source voltage. In addition, capacitor voltage balancing is not essential since the floating capacitors are effectively balanced during the charging and discharging processes. Furthermore, the proposed topology eliminates the need for multiple isolated dc sources, and a single dc source is sufficient in both its single-phase and three-phase topologies. The operating principle and steady-state analysis of the proposed topology are elaborated. Experimental results from a single-phase prototype are then presented to verify the validity of the proposed topology. [ABSTRACT FROM AUTHOR]