Search

This paper presents the interleaved operation of a soft-switching boost converter operated in boundary conduction mode. First, the operating principle of the converter as well as the basic concept of the interleaving is presented. Then, the dynamic behavior is modeled using the z-transform to obtain a converter model that is independent of the switching frequency. With the model, the stability of the closed-loop system with a proportional–integral (PI) controller is analyzed. It is shown that an adaptive PI controller can be easily implemented to achieve a minimal settling time over a wide operating range. Finally, the controller is validated with two converters with a 40-kW nominal output power and an output voltage of 3 kV. The tests at different output voltages under different load conditions show a stable interleaved operation. [ABSTRACT FROM PUBLISHER]

In this paper, the charging precision of a 40-kW 3-kV soft-switching boost converter for capacitor charging is investigated. At the beginning, an overview on the topology and the control of the converter is given. Then, two different feedback controllers are presented and compared analytically to determine their sensitivity on noisy input variables. An algorithm to investigate the charging precision is illustrated. This algorithm considers the signal-to-noise ratio (SNR) of all measured signals, the controller output limitations, quantization related errors, the finite resolution in the digital domain, and the switching signal jitter to calculate the charging precision. All effects mentioned before are analyzed separately. This analysis shows that the output voltage measurement SNR is the key parameter for the charging precision. Then, measurements are performed to verify the model used to calculate the precision. These measurements show that the measured precision is only 6% higher than the precision predicted by the model for the used setup. Finally, the charging precision of the presented converter is analyzed including all considered effects. The repetition accuracy of the converter is determined to be 8.3 ppm at an output voltage of 3 kV, neglecting the load connection and the input voltage variation during one switching cycle. [ABSTRACT FROM PUBLISHER]