Search

An optimized configuration of bidirectional Z-source circuit breaker using a coupled inductor is introduced for the fault isolation in low-voltage dc microgrid. The proposed circuit breaker is designed to operate with a single coupled inductor for bidirectional power flow. Use of the single coupled inductor for the power flow in both the directions reduces the component count. In this article, the operating principle of the breaker is explained for a short-circuit fault condition and breaker design criteria are derived. The performance of the circuit breaker is evaluated by carrying out a MATLAB simulation study. The functional prototype is developed to validate the breaker capabilities. Experimental results show that the fault is cleared within few microseconds. Additionally, the breaker is tested under the step load change condition for a current five times the steady-state rated current of the breaker and results are satisfactory. [ABSTRACT FROM AUTHOR]

This paper discusses the analysis and experimental validation of bidirectional Z-source breaker and bidirectional Z-source breaker using coupled inductor for low-voltage dc microgrid application. The proposed topologies use an SCR as a switch to isolate the fault from the system, and LC network to generate required commutation conditions for the SCR under fault conditions. Thus, both topologies are able to isolate the fault naturally within a few microseconds without any fault detection and sensing circuit. In this paper, the breaker operating principle is discussed during fault condition and breaker design criteria are derived. When the breaker is connected in series with power electronic converter, Z-source components offer filtering characteristic. The filtering characteristic offered by the breaker components is analyzed. Functional prototypes are developed for both configurations to validate the breaker performance and experimental results are presented. [ABSTRACT FROM AUTHOR]

In recent years, modular multilevel converter (MMC) is considered for medium-voltage variable speed drives (VSD) due to its modularity and higher reliability. However, the major drawback of the MMC-based VSD is the higher capacitor ripple voltage at lower operating speeds. In literature, this ripple voltage is reduced by injecting a high-frequency circulating current into each arm. This additional circulating current increases the overall current rating of the devices, inductors, and capacitors. Alternatively, the capacitor ripple voltage can be reduced at the lower output frequency by reducing the dc-bus voltage. This paper proposes a new configuration using a multipulse diode-bridge rectifier to reduce the dc-bus voltage when the drive is operated at lower speeds. Therefore, the capacitor ripple voltage decreases without injecting any circulating current. In addition, a new technique is proposed to maintain the peak-to-peak value of the submodule capacitor ripple voltage constant at near-zero speed. The proposed converter with 24-pulse rectifier configuration is simulated in MATLAB/Simulink, and the experimental validation is carried out on a prototype with 12-pulse rectifier. [ABSTRACT FROM AUTHOR]