Search

In this paper, the general design of a battery buffer system (BBS) consisting of a dc/dc converter and electric double layer capacitors for an electric vehicle is presented. This is intended to save the regenerative braking energy and to support the battery during acceleration. The design of a multiphase converter in interleaved operation with nonideal coupled inductors is stated to minimize volume and power losses while maintaining given current ripple limitations. A reduced sensor current-sharing control method is developed and its correct choice of the sensor position is explained. The peak efficiency of the designed and built converter can be measured to nearly 99%. The corresponding BBS is implemented in a lead-acid battery powered electric lift truck propulsion system. The system operation with and without the BBS is compared to examine the behavior and the overall efficiency. It can be shown that the traction battery stress can be strictly reduced as well as the temperature rise in the battery. Furthermore, the efficiency can be increased in the range of 5-6%. The battery's lifetime improvement is estimated by means of the difference in the temperature rise to approximately 20%. [ABSTRACT FROM AUTHOR]

Passive damping is the most adopted method to guarantee the stability of LCL-filter-based grid converters. The method is simple and, if the switching and sampling frequencies are sufficiently high, the damping losses are negligible. This letter proposes the tuning of different passive damping methods and an analytical estimation of the damping losses allowing the choice of the minimum resistor value resulting in a stable current control and not compromising the LCL-filter effectiveness. Stability, including variations in the grid inductance, is studied through root locus analysis in the z-plane. The analysis is validated both with simulation and with experiments. [ABSTRACT FROM AUTHOR]

DC-link current harmonics are the predominant factor to be considered for dimensioning dc capacitors in three-phase pulsewidth-modulation (PWM) voltage-source converters. In this paper, an analysis of the dc-link current harmonics applying a double Fourier series is derived. The analytical results for the dc-link current spectra of continuous and discontinuous PWMs are presented and compared with measurement results taken from a converter test setup. A good match between theoretically expected and actually obtained experimental results can be stated. Moreover, characteristic differences between the investigated modulation strategies regarding their dc-link current spectra become evident. [ABSTRACT FROM AUTHOR]