Search

This paper presents a unique modulation method for extending the input range of pulse-width modulation (PWM)-integrated resonant converters, such as the isolated boost resonant converter, while maintaining high conversion efficiency. The technique includes primarily the hybridizing of constant-on, constant-off, and fixed-frequency control depending only on the required duty cycle. The modulation scheme reduces core loss and conduction loss dramatically by decreasing the applied volt-seconds at the transformer and improving the switching period utilization. With hybrid-frequency control, the circuit also maintains zero current switching for the output diodes, minimizes switching loss, and eliminates circulating energy at the transformer across the entire operating range. It also allows for a predictable voltage gain, dependent only on duty cycle and transformer turns ratio. A detailed loss analysis is provided and verified against a 180 W experimental prototype, with an input range of 12–48 V and a switching frequency range of 30–70 kHz. Implementation issues are also handled with a variety of solutions for realizing the modulation scheme. Experimental results show greater than 4% weighted efficiency improvement in the prototype using the proposed method. [ABSTRACT FROM AUTHOR]

Abstract: This paper presents a high-efficiency grid-connected photovoltaic (PV) module integrated converter (MIC) system with reduced PV current variation. The proposed PV MIC system consists of a high-efficiency step-up DC–DC converter and a single-phase full-bridge DC–AC inverter. An active-clamping flyback converter with a voltage-doubler rectifier is proposed for the step-up DC–DC converter. The proposed step-up DC–DC converter reduces the switching losses by eliminating the reverse-recovery current of the output rectifying diodes. To reduce the PV current variation introduced by the grid-connected inverter, a PV current variation reduction method is also suggested. The suggested PV current variation reduction method reduces the PV current variation without any additional components. Moreover, for centralized power control of distributed PV MIC systems, a PV power control scheme with both a central control level and a local control level is presented. The central PV power control level controls the whole power production by sending out reference power signals to each individual PV MIC system. The proposed step-up DC–DC converter achieves a high-efficiency of 97.5% at 260W output power to generate the DC-link voltage of 350V from the PV voltage of 36.1V. The PV MIC system including the DC–DC converter and the DC–AC inverter achieves a high-efficiency of 95% with the PV current ripple less than 3% variation of the rated PV current. [Copyright &y& Elsevier]

High power boost converter has become the essential part of the distributed power system that enables energy to be fully utilized in fuel cell powered electric vehicles and stationary power systems. This paper presents analysis and design of a high-power multileg interleaved boost converter with a digital signal processor (DSP) based controller. A 20-kW converter was designed with coupled inductors to allow core-loss reduction and designed with high frequency switching to minimize the component size and eliminate the switching losses under discontinuous conducting mode operation. A dual-loop average current mode current control method implemented in DSP is employed to achieve the fast transient response. It was found through circuit analysis, simulation and experiment that the boost inductor interacted with the device parasitic capacitor and created unnecessary oscillating current whenever it reached zero current. Two high-power devices were used in both simulation and experiment to verify the analysis and design for a wide load range. Simulation and experiment results of the 20-kW boost converter under startup condition and load transient condition are also presented. Different anti-windup schemes for a typical PI-controller are evaluated. The results show that this typical controller with proper anti-windup scheme achieves better transient performance than without anti-windup scheme. [ABSTRACT FROM AUTHOR]