Search

For an ideal electron interlayer, both electron injection and hole‐blocking properties are important to achieve better polymer light‐emitting devices (PLEDs) performance. Conjugated polyelectrolytes (CPEs) are applied widely in PLEDs to enhance charge injection. Understanding the role of backbone structures and energetic matching between the CPEs and emitters can benefit charge injection and balance. Herein, a postpolymerization approach to introduce varying amounts of alkyl sulfonate groups onto the backbone of a copolymer of 5‐fluoro‐2,1,3‐benzothiadiazole and 9,9′‐dioctylfluorene is utilized. This study finds that device performance is dependent on the percentage of sulfonate groups incorporated, with the optimal copolymer (CPE‐50%) maintaining efficient ohmic electron injection and gaining enhanced hole‐blocking properties, thereby achieving the most balanced hole/electron current. Therefore, the PLED with CPE‐50% interlayer exhibits the highest efficiency (20.3 cd A−1, 20.2 lm W−1) and the fastest response time (4.3 µs), which is the highest efficiency among conventional thin (70 nm) F8BT PLEDs with CPEs. These results highlight the importance of balanced charge carrier density in CPEs and highlight that postpolymerization modification is a useful method for fine‐tuning ionic content. [ABSTRACT FROM AUTHOR]

Charge carrier injection and transport in polymer light‐emitting diodes (PLEDs) is strongly limited by the energy level offset at organic/(in)organic interfaces and the mismatch in electron and hole mobilities. Herein, these limitations are overcome via electrochemical doping of a light‐emitting polymer. Less than 1 wt% of doping agent is enough to effectively tune charge injection and balance and hence significantly improve PLED performance. For thick single‐layer (1.2 µm) PLEDs, dramatic reductions in current and luminance turn‐on voltages (VJ = 11.6 V from 20.0 V and VL = 12.7 V from 19.8 V with/without doping) accompanied by reduced efficiency roll‐off are observed. For thinner (<100 nm) PLEDs, electrochemical doping removes a thickness dependence on VJ and VL, enabling homogeneous electroluminescence emission in large‐area doped devices. Such efficient charge injection and balance properties achieved in doped PLEDs are attributed to a strong electrochemical interaction between the polymer and the doping agents, which is probed by in situ electric‐field‐dependent Raman spectroscopy combined with further electrical and energetic analysis. This approach to control charge injection and balance in solution‐processed PLEDs by low electrochemical doping provides a simple yet feasible strategy for developing high‐quality and efficient lighting applications that are fully compatible with printing technologies. [ABSTRACT FROM AUTHOR]