Search

Dense smoke from wildfires within a 500-kV line corridor led to several line protection trips over a three-day period. A switchable line-connected reactor, provided to control Ferranti voltages, tripped and locked out twice by its protection shortly after the line was de-energized. Lockout operation prevented quick reactor reinsertion and impeded operational flexibility until visual inspections of the reactor were conducted on both occasions. Forensic investigation of the event concluded that the smoke increased the line capacitances. This created a near 60-Hz zero sequence resonant circuit when the line tripped and became de-energized along with the reactor. The resonant circuit amplified the capacitively coupled zero sequence 60-Hz voltage induced from circuits which run adjacent to the line for a short distance. The voltage amplification drove enough current through the reactor to trip the sensitive ground overcurrent protection. A holistic mitigation is designed to avoid reoccurrence of the incident and improve overall line reliability. The intent of this paper is to share lessons learned from the event investigation with peer utilities because this problem of unexpected operation of line shunt reactor protection has not previously been reported. [ABSTRACT FROM AUTHOR]

A BC Hydro regional system experienced a blackout after multiple 500 kV lines, sharing the same transmission corridor, were subjected to lightning strikes in the time span of about three minutes. These lines connect two large generating stations, regional loads, and five nonutility generators to the rest of the BC Hydro system. The protection scheme on the first line tripped three-phase and initiated autoreclose as designed. However immediately after three-phase opening, high magnitudes of low-frequency (about 9 Hz) currents appeared in the line shunt reactor, causing a protection trip, and aborting the autoreclose. Subsequent lightning strikes coupled with a pre-existing line outage disconnected both generating stations from each other as well as from the integrated system. The larger of two generating stations and almost all regional load formed an islanded subsystem, which eventually collapsed and blacked out. During the restoration of the subsystem, the system operator inadvertently picked up the entire regional system without load, causing steady-state resonant overvoltages higher than 145% and damaging a transmission customer. This paper shares lessons learned from forensic analysis of disturbances leading to regional blackout and describes the risk of unsafe overvoltages from near power frequency resonant condition during the restoration process. [ABSTRACT FROM PUBLISHER]

Single-phase trip and high-speed reclose (SPTR) schemes applied on extra-high-voltage (EHV) lines offer significant benefits over three-phase schemes as they help maintain synchronism and stability in sparse transmission networks. However, a secondary arc may persist and prevent timely recovery of the air insulation. In this situation, high-speed reclosing will attempt to re-energize the still-faulted line, adding stress to the system instead of benefiting the system from the SPTR scheme. Using staged fault and fault disturbance data recorded from several 500 kV lines, this paper presents validation of an enhanced hybrid scheme incorporating secondary arc extinction detection logic designed to avoid high-speed reclosing onto faults while also allowing single-phase reclose in cases where it would be successful. The new logic is now being applied to several 500 kV lines in BC Hydro to improve transmission system reliability. [ABSTRACT FROM PUBLISHER]