Search

Nowadays, several technologies and management strategies are proposed for upgrading wastewater treatment plants (WWTPs) in order to improve sludge stabilization or minimize sludge production. In order to make sure that this leads to overall improvements, their techno-economic and environmental performance has to be carefully evaluated. In response to this, the techno-economic and environmental performance was assessed for a considered model reference WWTP upgraded with separate treatment and disposal for primary and secondary sludge to provide guidance to research, policy and investment efforts. This paper departs in an experimental campaign carried out within the EU project “ROUTES” and describes an assessment of an upgrade of a WWTP, involving wet oxidation of primary sludge and thermophilic anaerobic digestion (integrated with thermal hydrolysis pre-treatment) for secondary sludge. The reference plant and the upgrade implied different disposal routes for the resulting sludges: incineration for the stabilized sludge deriving from the reference WWTP; agricultural land application for the secondary stabilized sludge from the upgraded plant and landfilling for the solid residue deriving from the wet oxidation process (as non-hazardous waste). The mass balance carried out for both reference and upgraded WWTPs showed a reduction of total sludge production (up to 45%) for the upgraded WWTP. The additional energy demand of the upgraded solution (+22.4 Wh/(PE d), PE: population equivalent) was partially balanced by the electric energy produced by combined heat and power unit installed in the upgraded WWTP (−18.08 Wh/(PE d)). The integrated assessment showed that the upgraded solution, although resulting in an increase of WWTP technical complexity, may contribute to environmental and economic advantages. The paper provides guidance in terms of which aspects need a more thorough evaluation when this upgrade is considered in real cases. [ABSTRACT FROM AUTHOR]

The management of sewage sludge is becoming a more and more important issue, both at national and international level, in particular due to the uncertain recovery/disposal future options. Therefore, it is clear that the development of new technologies that can mitigate the problem at the source by reducing sludge production is necessary, such as the European Directive 2008/98/EC prescribes. This work shows the results obtained with a thermophilic membrane reactor, for processing a biological sludge derived from a wastewater treatment plant (WWTP) that treats urban and industrial wastewater. Sewage sludge was treated in a thermophilic membrane reactor (TMR), at pilot-scale (1 m 3 volume), with alternate aeration cycles. The experimentation was divided into two phases: a “startup phase” during which, starting with a psychrophilic/mesophilic biomass, thermophilic conditions were progressively reached, while feeding a highly biodegradable substrate; the obtained thermophilic biomass was then used, in the “regime phase”, to digest biological sludge which was fed to the plant. Good removal yields were observed: 64% and 57% for volatile solids (VS) and total COD (COD tot ), respectively, with an average hydraulic retention time (HRT) equal to 20 d, an organic loading rate (OLR) of about 1.4–1.8 kg COD m −3 d −1 and aeration/non aeration cycles alternated every 4 h. [ABSTRACT FROM AUTHOR]