Search

Incorporation of collagen structural information into the study of biomechanical behavior of ascending thoracic aortic (ATA) wall tissue should provide better insight into the pathophysiology of ATA. Structurally motivated constitutive models that include fiber dispersion and recruitment can successfully capture overall mechanical response of the arterial wall tissue. However, these models cannot examine local microarchitectural features of the collagen network, such as the effect of fiber disruptions and interaction between fibrous and non-fibrous components, which may influence emergent biomechanical properties of the tissue. Motivated by this need, we developed a finite element based three-dimensional structural model of the lamellar units of the ATA media that directly incorporates the collagen fiber microarchitecture. The fiber architecture was computer generated utilizing network features, namely fiber orientation distribution, intersection density and areal concentration, obtained from image analysis of multiphoton microscopy images taken from human aneurysmal ascending thoracic aortic media specimens with bicuspid aortic valve (BAV) phenotype. Our model reproduces the typical J-shaped constitutive response of the aortic wall tissue. We found that the stress state in the non-fibrous matrix was homogeneous until the collagen fibers were recruited, but became highly heterogeneous after that event. The degree of heterogeneity was dependent upon local network architecture with high stresses observed near disrupted fibers. The magnitude of non-fibrous matrix stress at higher stretch levels was negatively correlated with local fiber density. The localized stress concentrations, elucidated by this model, may be a factor in the degenerative changes in aneurysmal ATA tissue., (Copyright © 2016 Elsevier Ltd. All rights reserved.)

We recently reported a mechanistic model to link micro-architectural information to the delamination strength (Sd) of human ascending thoracic aorta (ATA). That analysis demonstrated that the number density (N) and failure energy (Uf) of the radially-oriented collagen fibers contribute to the Sd of both aneurysmal (ATAA) and non-aneurysmal (CTRL-ATA) aortic tissue. Among the set of ATAA samples, we studied specimens from patients displaying bicuspid (BAV) and tricuspid aortic valve (TAV) morphologic phenotypes. Results from our prior work were based on the assumption that the Uf was independent of dissection direction. In the current study, we excluded that assumption and hypothesized that Uf correlates with the Sd of ATAA. To test the hypothesis, we used previously-reported experimentally-determined Sd measurements and N of radially-oriented collagen fibers as input in our validated mechanistic model to calculate Uf for BAV-ATAA, TAV-ATAA and CTRL-ATA tissue specimens. The results of our analysis revealed that Uf is significantly lower for both BAV-ATAA and TAV-ATAA compared to CTRL-ATA cases, and does not differ between BAV-ATAA and TAV-ATAA. Furthermore, we found that Uf is consistent between circumferential-radial and longitudinal-radial planes in either of BAV-ATAA, TAV-ATAA or CTRL-ATA specimens. These findings employ a novel mechanistic model to increase our understanding of the putative interrelationship between biomechanical properties, extracellular matrix biology, and failure energy of aortic dissection., (Copyright © 2014 Elsevier Ltd. All rights reserved.)

Background: Ascending thoracic aortic aneurysm (ATAA) predisposes patients to aortic dissection and has been associated with diminished tensile strength and disruption of collagen. Ascending thoracic aortic aneurysms arising in patients with bicuspid aortic valve (BAV) develop earlier than in those with tricuspid aortic valves (TAV) and have a different risk of dissection. The purpose of this study was to compare aortic wall tensile strength between BAV and TAV ATAAs and determine whether the collagen content of the ATAA wall is associated with tensile strength and valve phenotype., Methods: Longitudinally and circumferentially oriented strips of ATAA tissue obtained during elective surgery were stretched to failure, and collagen content was estimated by hydroxyproline assay. Experimental stress-strain data were analyzed for failure strength and elastic mechanical variables: α, β, and maximal tangential stiffness., Results: The circumferential and longitudinal tensile strengths were higher for BAV ATAAs when compared with TAV ATAAs. The α and β were lower for BAV ATAAs when compared with TAV ATAAs. The maximal tangential stiffness was higher for circumferential when compared with longitudinal orientation in both BAV and TAV ATAAs. The amount of hydroxyproline was equivalent in BAV and TAV ATAA specimens. Although there was a moderate correlation between the collagen content and tensile strength for TAV, this correlation is not present in BAV., Conclusions: The increased tensile strength and decreased values of α and β in BAV ATAAs despite uniform collagen content between groups indicate that microstructural changes in collagen contribute to BAV-associated aortopathy., (Copyright © 2013 The Society of Thoracic Surgeons. Published by Elsevier Inc. All rights reserved.)

It was recently demonstrated by our group that the delamination strength of ascending thoracic aortic aneurysms (ATAA) was lower than that of control (CTRL, non-aneurysmal) ascending thoracic aorta (ATA), and the reduced strength was more pronounced among bicuspid (BAV) vs. tricuspid aortic valve (TAV) patients, suggesting a different risk of aortic dissection for BAV patients. We hypothesized that aortic valve morphologic phenotype predicts fiber micro-architectural anomalies in ATA. To test the hypothesis, we characterized the micro-architecture in the longitudinal-radial (Z-RAD) and circumferential-radial (Θ-RAD) planes of human ATA tissue that was artificially dissected medially. The outer and inner-media of CTRL-ATA, BAV-ATAA and TAV-ATAA were imaged using multi-photon microscopy in the Z-RAD and Θ-RAD planes to observe collagen and elastin. Micrographs were processed using an image-based tool to quantify several micro-architectural characteristics. In the outer-media of BAV-ATAA, elastin was more undulated and less aligned about the Θ-axis when compared with CTRL-ATA, which is consistent with increased tensile stretch at inflection point of Θ-strips of adventitial-medial half of BAV-ATAA (1.28) when compared with CTRL-ATA (1.13). With increasing age, collagen became more undulated about the Z-axis within the outer-media of TAV-ATAA, and elastin became more oriented in the Z-axis and collagen less radially-oriented within the inner-media of TAV-ATAA. This discrepancy in the micro-architecture with fibers in the inner layers being more stretched and with disrupted radially-oriented components than fibers in the outer layers may be associated with the development, progression and vascular remodeling in aneurysms arising in TAV patients., (© 2013 Elsevier Ltd. All rights reserved.)

Background: The mechanisms governing extracellular matrix degradation and smooth muscle cell (SMC) loss in the ascending aorta of bicuspid aortic valve (BAV) patients are unknown. We recently reported that expression and induction of metallothionein, a reactive oxygen species scavenger, is reduced in BAV ascending aortic aneurysms relative to nonaneurysmal patients. Methods: Tissue and primary SMCs from patients with and without thoracic aortic aneurysms and metallothionein-null and wild-type mice were analyzed for cell viability, vascular endothelial growth factor (VEGF), and type I collagen gene expression during exposure to reactive oxygen species. Results: The BAV SMCs and metallothionein −/− mice failed to induce VEGF under conditions of oxidative stress in vitro. Exogenous VEGF restored resistance to oxidative stress in BAV SMCs to normal. Type I collagen gene induction was increased in BAV aorta. Conclusions: Lack of VEGF induction during exposure to reactive oxygen species suggest that the oxidative stress response is faulty upstream of metallothionein and VEGF in BAV SMCs. Improvement of cell viability with VEGF treatment suggests that the deficient pathway can be rescued by VEGF. Increased type I collagen in BAV suggests that lack of metallothionein/VEGF activation in response to reactive oxygen species may play a role in extracellular matrix homeostasis of the ascending aorta. These data continue to support our hypothesis that BAV SMCs lack sufficient resistance to reactive oxygen species to maintain extracellular matrix homeostasis, which imparts a predisposition to thoracic aortic aneurysms. [ABSTRACT FROM AUTHOR]

Objective Ascending thoracic aortic aneurysm (ATAA) in patients with bicuspid aortic valve (BAV) commonly dilate asymmetrically compared with patients with tricuspid aortic valve (TAV). This discrepancy in aneurysm geometry led us to hypothesize that microarchitectural differences underlie the observed asymmetric dilatation pattern. The purpose of this study was to characterize the microarchitectural distinctions of the extracellular matrix of the 2 phenotypes with a focus on the proportion of radially oriented elastin and collagen fibers in different circumferential aortic regions. Methods Aortic tissue rings were obtained just distal to the sinotubular junction from patients with BAV or TAV undergoing elective aneurysm repair. They were sectioned into three circumferentially based regions according to adjacent aortic sinus segment (left coronary sinus [L], right coronary sinus [R], or noncoronary sinus [N]). Multiphoton microscopy was used to quantify and characterize the number of radially oriented elastin and collagen fibers. Results There were fewer radially oriented fibers in medial region N and medial-intimal region R of BAV-ATAAs when compared with TAV-ATAAs (medial region N, amplitude of angular undulation of elastin = 10.67° ± 1.35° vs 15.58° ± 1.91°; P = .041; medial-intimal region R, amplitude of angular undulation of elastin = 9.83° ± 0.83° vs 14.72° ± 1.64°; P = .015). Conversely, fibers became more radially oriented in the medial-intimal region L of BAV-ATAA when compared with TAV-ATAA (amplitude of angular undulation of collagen = 18.67° ± 0.95° vs 14.56° ± 1.37°; P = .041). Conclusions The differential pattern of fiber orientation noted between L and N-R regions help explain the unique pattern of greater curvature dilatation of BAV-ATAA. The distinctions noted in matrix microarchitecture may form the basis of differing aneurysm geometries and aortic wall integrities in ATAAs arising in these different valve morphologies. [ABSTRACT FROM AUTHOR]