Search

The dosimetric characteristics of three multileaf collimator (MLC) systems (Elekta, Siemens and Varian) having 10 mm leaf width are compared. A 6 MV photon beam was used from each unit for measurements. Film dosimetry was performed for the measurements and the analysis techniques were exactly duplicated in each system. Two of the collimators have rounded leaf ends (Elekta and Varian) and the third (Siemens) has a flat end that follows beam divergence. A scanning densitometer (Wellhöfer with 0.45 mm spot and 0.5 mm step size) was used for film analysis. The dosimetric characteristics studied include: penumbra width (80-20%) as a function of position of the leaf end in the field, inter- and intra-leaf radiation leakage, dose distribution of the tongue and groove, and isodose curves for stepped leaves forming 45 degrees angle beam edge. Results show that MLC designs with divergent and non-divergent leaves produce penumbra (80-20%) widths that are within 2.0 mm of each other. However, the distance of the collimator from the x-ray target plays an important role, and the smallest penumbra width was noted for the Varian MLC despite its rounded leaf-end design. Compared to the other systems, this collimator is positioned about 15 cm closer to the patient which affects the skin dose. The MLC with flat leaf end, although closer to the target, showed slightly poorer penumbra width. Inter-leaf leakage through the leaves is 1.3% for two of the collimators (Elekta and Varian) with the backup jaws and is nearly 1% for the third system (Siemens). The Siemens MLC produces reduced tongue-and-groove effect compared to the other two collimators (Elekta and Varian). The isodose undulation for a stepped edge is found to be significant for the collimator closest to the patient (Varian) and does not depend on the leaf-end shape. There is no perfect MLC system that can be recommended, rather each one has unique advantages and disadvantages that should be weighed with comfort, ease and cost effectiveness for clinical use.

To facilitate the use of multileaf collimator (MLC) in field shaping, we tested the hypothesis that the changes in the penumbra due to MLC replacing a Cerrobend block can be related to a change in the margin of the block. We also investigated if it is possible to estimate the effect of MLC replacing a block in terms of a change in the block margin. Calculations were performed for a single field as well as a multiple field setup. For the single field setup, blocks with equal areas were drawn at the four corners of a 16 x 20 cm(2) field at angles of 20 degrees, 40 degrees, 60 degrees, and 80 degrees with the horizontal axis. The blocks were then replaced with MLC leaves. For 6 MV x-rays, dose profiles in the penumbra regions of the blocks at 5- and 10-cm depths were compared with those obtained with the corresponding MLC setup. For multiple fields, the same sets of blocks were set up on the anterio-posterior (AP-PA) pair of a four-field setup. The margins of the blocks were increased (i.e., block shaved) in 1 mm steps to a maximum of 6 mm. The similarity between MLC and the change in the block margin was examined by comparing the dose-volume histogram (DVH) of the normal tissues in the penumbral regions for the different setups. To correlate the effect of MLC with a change in the block margin, difference dose-volume histograms (DDVH) of the normal tissues relative to the original block were compared for the MLC setup with those for the changes in the block margin. The correlation obtained was used to predict the effect on the penumbra region of the MLC setup for the lateral fields of a patient irradiated with a four-field setup. The calculations were carried out with 15 MV x-rays. For the single field setup, dose undulation is largest for the 50% isodose line (IDL) as reflected in the largest increase in the 50% to 20% isodose region compared with the 90% to 10% and the 80% to 20% regions. The increase in the penumbral width is largest for the 20 degrees block when replaced by the MLC and is smaller as the angle increases. The increase in the penumbral width also increases with depth. The effect of replacing a Cerrobend block with an MLC is similar to an increase in the block margin. For 15 MV x-rays, the increase varies inversely with the angle of the blocks, from6 mm increase in block margin for the 20 degrees block to about 1 mm for the 80 degrees block. In the clinical example, replacing the blocks in the lateral fields of a four-field irradiation with MLC is similar to changing the margin of the blocks. For the posterior block, MLC is similar to a 1- to 2-mm increase in the margin of the block, whereas for the anterior block the effect is similar to 1 mm for the straight portion of the block to about 6 mm in the superior portion of the block. Characterization of an MLC setup replacing a Cerrobend block is necessary for adequate coverage of target volume. The effect of MLC replacing a Cerrobend block is similar to a change in the block margin. It is possible to estimate with reasonable accuracy the effect of MLC replacing a Cerrobend block.