Search

This article describes the use of a cationized starch-based material as new ion-exchanger adsorbent for the removal of C.I. Acid Blue 25 (AB 25) from aqueous solutions. Batch adsorption studies concerning the effects of contact time, pH and temperature are presented and discussed. Adsorption experimental data showed that: (i) the process was uniform and rapid: adsorption of dye reached equilibrium in 50 min in the wide pH range of dye solutions; (ii) adsorption kinetics followed the pseudo-second order model; (iii) the Langmuir model yielded a much better fit than the Freundlich model for the dye concentration range under study; (iv) this adsorbent exhibited interesting adsorption capacities: on the basis of the Langmuir analysis, the maximum adsorption capacity was determined to be 322 mg of dye per gram of material at 25 degrees C; (v) the adsorption capacity decreased with increasing temperature; and (vi) the negative value of free energy change indicated the spontaneous nature of adsorption.

This article describes the adsorption of an anionic dye, namely C.I. Acid Blue 25 (AB 25), from aqueous solutions onto a cationized starch-based adsorbent. Temperature was varied to investigate its effect on the adsorption capacity. Equilibrium adsorption isotherms were measured for the single component system and the experimental data were analyzed by using Langmuir, Freundlich, Tempkin, Generalized, Redlich-Peterson, and Toth isotherm equations. Five error functions were used to determine the alternative single component parameters by non-linear regression due to the bias in using the correlation coefficient resulting from linearization. The error analysis showed that, compared with other models, the Langmuir model described best the dye adsorption data. Both linear regression method and non-linear error functions provided the best-fit to experimental data with the Langmuir model.

Chitosan-based adsorbent (CHITOD material) is used for the removal of Basic Blue 3 (BB 3) from aqueous solutions. The adsorption of BB 3 on CHITOD material was studied as a function of time, sorbent mass and concentration. The influence of these parameters on the adsorption capacity was evaluated using the batch method. Results of adsorption experiments and kinetic data showed that (i) the CHITOD adsorbent exhibited high sorption capacities toward BB 3; (ii) the Langmuir equation represented the best fit of experimental data; (iii) the dye sorption on material was exothermic and spontaneous in nature; (iv) the kinetic measurements showed that the process was rapid; (v) the adsorption kinetics followed a pseudo-second order model; and (vi) the sorption was dependent on the presence of sulfonate groups. Non-linear method was also found to be more appropriate method for estimating the isotherm and kinetic parameters.

Adsorption techniques are widely used to remove certain classes of pollutants from waters, especially those that are not easily biodegradable. Dyes represent one of the problematic groups. Currently, a combination of biological treatment and adsorption on activated carbon is becoming more common for removal of dyes from wastewater. Although commercial activated carbon is a preferred sorbent for color removal, its widespread use is restricted due to high cost. As such, alternative non-conventional sorbents have been investigated. It is well-known that natural materials, waste materials from industry and agriculture and biosorbents can be obtained and employed as inexpensive sorbents. In this review, an extensive list of sorbent literature has been compiled. The review (i) presents a critical analysis of these materials; (ii) describes their characteristics, advantages and limitations; and (iii) discusses various mechanisms involved. It is evident from a literature survey of about 210 recent papers that low-cost sorbents have demonstrated outstanding removal capabilities for certain dyes. In particular, chitosan might be a promising adsorbent for environmental and purification purposes.

Beta-cyclodextrin (beta-CD) polymers are used for the removal of various dyes from aqueous solutions. Three insoluble polymers with different degrees of beta-CD were used. Results of adsorption experiments showed that these polymers exhibited high sorption capacities toward dyes. The mechanism of adsorption was both physical adsorption and hydrogen bonding due to the polymer and the formation of an inclusion complex due to the beta-CD molecules through host-guest interactions.