Search

In this paper, numerical simulations were carried out to identify the mode of ignition and ignition delay time of pulverized biomass particles in hot flue gas produced by a methane/air flame. In the experiments, it was observed that for most biomass residues the dominant combustion mode was the staged gas-phase ignition in the surrounding gas followed by surface ignition at the char surface. There were some exceptions to this general trend, e.g. wheat straw particles, which ignited at the surface of the particle under some temperature conditions. Moreover, temporally and spectrally resolved images of the single burning particles were obtained in the experiments and CH* chemiluminescence at different stages of biomass conversion was recorded. In this study, by means of a detailed numerical model for conversion of biomass particles and employing detailed gas chemistry mechanism, the ignition mode and ignition delay time of the particles are studied. The model is able to distinguish between different ignition modes of the particles in agreement with the experimental data. The underlying physics behind shifting ignition mode from homogeneous ignition to heterogeneous ignition for wheat straw are discussed. The ignition delay times for different biomass sources at different conditions are calculated and the results are in good agreement with the experimental data. Apart from the detailed model, CFD simulations are performed to assess the flow and combustion process (temperature, O 2 concentration and velocity difference between the ambient gas and the particle) around the particle. The CFD results show similar trends compared with the CH* chemiluminescence from the particle at different times during the devolatilization stage. [ABSTRACT FROM AUTHOR]

Transient mixing and ignition mechanisms in a simplified pre-chamber/main-chamber system are investigated using direct numerical simulation (DNS) with detailed chemical kinetics. Full ignition and flame propagation processes in the premixed methane/air mixtures are simulated. Ignition, the progress and topology of flame evolution, and the mean burning velocity in the main chamber are analyzed in detail. Four important phases in the ignition and flame propagation processes are identified based on the flame structure development in the main chamber, the pressure and velocity evolution at typical points in both the pre-chamber and main chamber. Results show that the intermediate species OH, CH 2 O, and HO 2 are critical for flame stabilization and propagation in the main chamber due to their high reactivity. This is sorted as the chemical effect that the pre-chamber jet acts on the main chamber. The high temperature jet also brings heat and unburned fuel into the main chamber, which are sorted as thermal and enrichment effect, respectively. The heat release rate is found to be approximately proportional to the product of CH 2 O and OH mass fractions, which could be regarded as a reliable and effective marker for the heat release rate of methane/air mixtures. It is found that the mean burning velocity in the main chamber can be elevated up to 30 times under the condition investigated. [ABSTRACT FROM AUTHOR]