Search

Variable-pressure scanning electron microscopy was used to investigate the dimensional changes in longitudinal, tangential and radial directions, on wetting and drying, of tracheids of opposite wood (OW) and three grades of compression woods (CWs), including severe CW (SCW) and two grades of mild compression wood (MCW) (MCW1 and MCW2) in corewood of radiata pine (Pinus radiata) saplings. The CW was formed on the underside and OW on the upper side of slightly tilted stems. In the longitudinal direction, the shrinkage of SCW tracheids was ~300% greater than that of OW tracheids, with the shrinkage of the MCW1 and MCW2 tracheids being intermediate. Longitudinal swelling was also investigated and hysteresis was demonstrated for the tracheids of all corewood types, with the extent of hysteresis increasing with CW severity. A statistical association was found between longitudinal shrinkage and the content of lignin and galactosyl residues in the cell-wall matrix. The galactosyl residues are present mostly as (1→4)-β-galactans, which are known to have a high capacity for binding water and swell on hydration. The small proportions of (1→3)-β-glucans in the CWs have similar properties. These polysaccharides may play a functional role in the longitudinal shrinking and swelling of CW tracheids. Tangential shrinkage of tracheids was greater than radial shrinkage but both were greatest for OW and least for SCW, with the MCW1 and MCW2 being intermediate. [ABSTRACT FROM AUTHOR]

Background: Compression wood (CW) forms on the underside of tilted stems of coniferous gymnosperms and opposite wood (OW) on the upperside. The tracheid walls of these wood types differ structurally and chemically. Although much is known about the most severe form of CW, severe CW (SCW), mild CWs (MCWs), also occur, but less is known about them. In this study, tracheid wall structures and compositions of two grades of MCWs (1 and 2) and SCW were investigated and compared with OW in slightly tilted radiata pine (Pinus radiata) stems. Results: The four wood types were identified by the distribution of lignin in their tracheid walls. Only the tracheid walls of OW and MCW1 had a S3 layer and this was thin in MCW1. The tracheid walls of only SCW had a S2 layer with helical cavities in the inner region (S2i). Using immunomicroscopy, (1→4)-β-D-galactans and (1→3)-β-D-glucans were detected in the tracheid walls of all CWs, but in only trace amounts in OW. The (1→4)-β-D-galactans were located in the outer region of the S2 layer, whereas the (1→3)-β-D-glucans were in the inner S2i region. The areas and intensities of labelling increased with CW severity. The antibody for (1→4)-β-D-galactans was also used to identify the locations and relative amounts of these galactans in whole stem cross sections based on the formation of an insoluble dye. Areas containing the four wood types were clearly differentiated depending on colour intensity. The neutral monosaccharide compositions of the non-cellulosic polysaccharides of these wood types were determined on small, well defined discs, and showed the proportion of galactose was higher for CWs and increased with severity. Conclusion: The presence of an S3 wall layer is a marker for very MCW and the presence of helical cavities in the S2 wall layer for SCW. The occurrence and proportions of (1→4)-β-D-galactans and (1→3)-β-D-glucans can be used as markers for CW and its severity. The proportions of galactose were consistent with the labelling results for (1→4)-β-D-galactans. [ABSTRACT FROM AUTHOR]

Copyright of Canadian Journal of Forest Research is the property of Canadian Science Publishing and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)

The potential of pyrolysis followed by gas-chromatography and mass-spectrometry (Py-GC/MS) was investigated for identifying compression wood (CW) in saplings of radiata pine ( Pinus radiata) by examining samples of CW and opposite wood (OW). Phenolic compounds and anhydrosugars were identified among the pyrolysis products that provided information about the cell-wall polymers. Sample preparation, such as coarse-milling, fine-milling, and fine-milling followed by calcium-chloride treatment was also investigated. Fine-milling typically decreased the total yield of phenolic compounds compared with coarse-milling. Fine-milling followed by calcium-chloride washing significantly increased the proportions of pyrolysis products from polysaccharides, specifically from (1→4)-β-D-galactans that were of interest in distinguishing CW from OW. Six pyrolysis products were identified that were unique to the CW samples examined, including derivatives of (1→4)-β-D-galactans and H-units of lignin. Other pyrolysis products were identified that had significantly different proportions between the two wood types, and sometimes among samples of the same wood type. [ABSTRACT FROM AUTHOR]

Polysaccharides were located in the walls of normal and compression wood tracheids of Pinus radiata (radiata pine), Picea sitchensis (Sitka spruce) and Picea abies (Norway spruce) by transmission electron microscopy using immunogold labelling with monoclonal antibodies to (1→4)-β-galactan (LM5), (1→3)-β-glucan, arabinogalactan proteins (AGPs) (MAC207) and heteroxylans (LM10 and LM11). In fully differentiated compression wood tracheids, (1→4)-β-galactan was found in the S2(L) layer and, to a smaller extent, at the interface between the compound middle lamella and the S1 layer. (1→4)-β-Galactan appeared to be displaced from, or modified in, the S1 layer during cell wall formation. (1→3)-β-Glucan (callose) was confined to the helical cavities in the inner S2 layer of severe compression wood. MAC207 AGP glycan epitope was found exclusively in the S1 and S3 layers of normal wood tracheids and in the S1 and inner S2 layers of compression wood tracheids. Binding of LM10, which specifically recognizes unsubstituted or low-substituted xylans, occurred at similar locations to the MAC207 epitope, whereas binding of LM11, which recognizes more highly substituted as well as unsubstituted xylans, occurred throughout the tracheid walls with the exception of the primary wall. Immunogold labelling showed that the different wall layers of softwood tracheids have different polysaccharide compositions which change abruptly during cell wall formation. [ABSTRACT FROM PUBLISHER]

Near infrared (NIR) spectroscopy coupled with partial least squares (PLS-1) regression was used to predict the lignin contents and monosaccharide compositions of milled wood of Pinus radiata . The effects of particle size and moisture content were investigated by collecting NIR spectra of four sample types: large (<0.422 mm) and small (<0.178 mm) particles, in both ambient and dry conditions. PLS-1 models were constructed using mixtures of compression wood (CW) and opposite wood (OW) that provided a linear range of cell-wall compositions. Our results show that lignin contents and monosaccharide compositions of pure CWs and OWs can be successfully predicted using NIR spectra of all four sample types. However, large particles in ambient conditions have the most efficient preparation and the standard error (SE) values for lignin (2.10%), arabinose (0.34%), xylose (1.33%), galactose (2.54%), glucose (6.98%), mannose (1.48%), galacturonic acid (0.22%), glucuronic acid (0.06%), and 4- O -methylglucuronic acid (0.25%) were achieved. [ABSTRACT FROM AUTHOR]

Tilted stems of softwoods form compression wood (CW) and opposite wood (OW) on their lower and upper sides, respectively. More is known about the most severe form of CW, severe CW (SCW), but mild CWs (MCWs) also occur widely. Two grades of MCWs, MCW1 and MCW2, as well as SCW and OW were identified in the stems of radiata pine ( Pinus radiata ) that had been slightly tilted. The four wood types were identified by the distribution of lignin in the tracheid walls determined by fluorescence microscopy. A solution of the fluorescent dye acridine orange (AO) (0.02% at pH 6 or 7) was shown to metachromatically stain the tracheid walls and can also be used to determine lignin distribution. The lignified walls fluoresced orange to yellow depending on the lignin concentration. Microscopically well-characterized discs (0.5 mm diameter) of the wood types were used to determine lignin concentrations and lignin monomer compositions using the acetyl bromide method and thioacidolysis, respectively. Lignin concentration and the proportion of p- hydroxyphenyl units (H-units) relative to guaiacyl (G-units) increased with CW severity, with <1% H-units in OW and up to 14% in SCW. Lignin H-units can be used as a marker for CW and CW severity. Similar discs were also examined by Raman and FTIR micro-spectroscopies coupled with principal component analysis (PCA) to determine if these techniques can be used to differentiate the four different wood types. Both techniques were able to do this, particularly Raman micro-spectroscopy. [ABSTRACT FROM AUTHOR]