Search

Membranebioreactors (MBRs) are becoming more suitable alternativesfor conventional wastewater treatment devices. The performance ofa pressure-driven MBR is dominantly affected by the hydrodynamic conditionsof the system. This study was conducted to investigate various hydrodynamiccharacteristics including shear stress, cross-flow velocity, and membranefouling resistance, using computational fluid dynamics (CFD). Simulationof two- and three-phase flow for a flat-sheet submerged membrane modulewas carried out, and the results were compared with the experimentaldata. The CFD simulation was implemented to analyze the fluid-flowpattern, shear stress on membrane surfaces, and cross-flow velocitybetween membranes at various mixed liquor suspended solid concentrationsin the bioreactor. It was shown that the cross-flow velocity playsan important role in the membrane fouling and determination of thecritical particle diameter. To achieve an optimal operating condition,the critical particle diameter was calculated at different air flowrates and permeate fluxes. The CFD results showed that the outermostmembranes are more prone to fouling because of the lower shear stresson their surface as well as the lower cross-flow velocity betweenthem and the module wall. Moreover, the effect of the air bubble diameteron the air and liquid shear stress was investigated to determine anoptimal bubble size. [ABSTRACT FROM AUTHOR]

Abstract: In this study, experiments and computational fluid dynamics were used to evaluate the fouling of membrane surfaces. Based on the resistance-in-series model, the total filtration resistance (R t ) was divided into cake resistance (R c ), adsorption resistance (R a ), internal-plugging (pore-blockage) resistance (R pb ) and intrinsic-membrane resistance (R m ). The values of each resistance and their relative percentages as a function of the operating parameters were experimentally determined. The effect of inlet air-flow rate and the baffle angle on the resistances were also investigated. It was then shown that the permeate flux and resistances could be related to the wall shear stresses of air and liquid flows at the membrane surface. Average shear stress was found to increase by increasing the air-flow rate. The change in baffle angle from 90° to 85° increased the shear stress of air on the membrane surface. At low air-flow rates there was a lower meandering of air as well as the area of the membrane, which is not subject to high-shear increases. The shear stresses of air and liquid on the membrane surface were determined by computational fluid dynamics and correlations were proposed for estimating each resistance of the membrane from these shear stresses. [Copyright &y& Elsevier]