Search

The influence of various seismic parameters on the seismic performance of rectangular reinforced recycled concrete columns was comprehensively revealed through collecting and screening experimental data from 53 rectangular recycled aggregate concrete columns. The research results showed that the bearing capacity of the specimens decreased and the ductility performance increased, which were attributed to the following factors. a. The increase in the replacement ratio and slenderness ratio of recycled coarse aggregate, and b. the reduction in the axial compression ratio and the strength of recycled aggregate concrete. The seismic design limitations and boundary conditions of this study are γ ∈ [0, 100%], n0 ∈ [0, 0.9], λ0 ∈ [5.06, 18.479], λ ∈ [1.09, 3.93], ρsl ∈ [1.01%, 2.45%], ρsv ∈ [1.4%, 5.33%], and f ∈ [C30, C50]. Thus, it is recommended that for the seismic design value of rectangular recycled aggregate concrete columns, the optimal longitudinal reinforcement rate be set at 1.59%. [ABSTRACT FROM AUTHOR]

To study the seismic behavior of unsymmetrical steel reinforced concrete column, cyclic loading tests were carried out on 12 columns with T-shaped section steel and 12 columns with L-shaped section steel. The test parameters included shear span ratio, axial compression ratio, stirrup ratio and presence of cross tie. Mechanical process, failure mode, hysteretic characteristics, skeleton curves, ductility and energy dissipation ability were taken into comparison. The result indicates that unsymmetrical steel reinforced concrete column possesses good seismic performance under constant axial compression and cyclic horizontal load. The failure modes include bonding failure, shear-bond failure, shear compression failure and shear-composition failure. Obvious asymmetry phenomenon of positive and negative hysteresis loop are shown. The span ratio has great influence on failure mode and shear-composition failure usually takes place in L-shaped steel section column. With the increase of axial compression ratio, the ductility decreases, which is obvious in L-shaped steel section column. The ductility and bearing capacity of the T-shaped steel section columns are improved greatly with the increase of stirrup ratio, but not obvious for T-shaped steel section column with smaller span ratio. Cross ties can improve bearing capacity, limit strength and stiffness degradation and enhance deformation capacity of L-shape steel section columns clearly. [ABSTRACT FROM AUTHOR]

• The mechanical property tests and test of GFRP reinforced hybrid fibre concrete short columns subjected to eccentric compression were conducted. • The cooperative effect of the GFRP reinforcement and the steel-PVA hybrid fibre concrete with different fibre ratios under eccentric loading was explored. • The addition of fibres can effectively prevent the crack generation and development and improve the bonding property between reinforcement bars and concrete. • The equation for the calculation of the ultimate compressive capacity of partial sections of eccentric columns is proposed. This paper presents the results of an experimental study carried out on the GFRP reinforced hybrid fibre concrete short columns subjected to eccentric compression. In this study, hybrid fiber-reinforced concrete was prepared in different volume ratios of hybrid fibers and the cooperative effect of the GFRP reinforcement and the steel-PVA hybrid fibre concrete with different fibre ratios under eccentric loading was explored. 10 GFRP reinforced hybrid fibre concrete short columns and 2 plain reinforced concrete short columns were tested to investigated their eccentric compressive properties. The tests results are presented in terms of failure modes, longitudinal reinforcement strain, concrete compressive strain and compressive load capacity of GFRP reinforced hybrid fibre concrete eccentrically compressed short columns. The results show that the concrete on the compressed side was crushed when the specimen under both the initial eccentricity of 50 mm and 100 mm the reinforcement were pulled on the tension side of specimen under a larger initial eccentricity of 100 mm. The addition of fibres can effectively prevent the crack generation and development and improve the bonding property between reinforcement and concrete. Besides, the addition of steel fibre contributes a better performance on the ultimate compressive capacity of specimen under a lager initial eccentricity with an optimal ratio of steel fibre at 1.4 %. PVA fibre effectively improve the ductility of the concrete, so that the hybrid fibre concrete elements remain relatively its integrity after failure. Finally, considering the effect of GFRP reinforcement and different ratios of steel fibre and PVA fibre on the compressive capacity of short concrete columns, the equation for the calculation of the ultimate compressive capacity of partial sections of eccentric columns is proposed, and a good agreement was observed between the tested and calculated value. [ABSTRACT FROM AUTHOR]