Search

Photocatalytic hydrogen evolution from natural seawater faces the severe challenges of abundant salts, which adsorb on the active sites and result in undesirable side reactions and photocatalyst poisoning. Herein, a series of main‐chain‐engineered discontinuously conjugated polymer (DCP) photocatalysts is presented with bifunctional crown ether (CE) structures for hydrogen evolution from seawater. The hydrophilic CE can significantly inhibit the aggregation of DCPs induced by salts. Meanwhile, cyclic CE can effectively adsorb cations to uncover the active sites to increase their interaction with protons, which can increase the hydrogen evolution rates and significantly reduce the efficiency roll‐off in natural seawater. Through atomistic studies, the formation of hydrogen bonds with bifunctional CE is elucidated and further analysis of the microscale mechanisms is also conducted using molecular dynamics and ab initio techniques. This work suggests that CE‐based polymer has the potential to enhance its ability to produce hydrogen through photocatalysis using seawater. [ABSTRACT FROM AUTHOR]

Photocatalytic water splitting is attracting considerable interest because it enables the conversion of solar energy into hydrogen for use as a zero-emission fuel or chemical feedstock. Herein, we present a universal approach for inserting hydrophilic non-conjugated segments into the main-chain of conjugated polymers to produce a series of discontinuously conjugated polymer photocatalysts. Water can effectively be brought into the interior through these hydrophilic non-conjugated segments, resulting in effective water/polymer interfaces inside the bulk discontinuously conjugated polymers in both thin-film and solution. Discontinuously conjugated polymer with 10 mol% hexaethylene glycol-based hydrophilic segments achieves an apparent quantum yield of 17.82% under 460 nm monochromatic light irradiation in solution and a hydrogen evolution rate of 16.8 mmol m−2 h−1 in thin-film. Molecular dynamics simulations show a trend similar to that in experiments, corroborating that main-chain engineering increases the possibility of a water/polymer interaction. By introducing non-conjugated hydrophilic segments, the effective conjugation length is not altered, allowing discontinuously conjugated polymers to remain efficient photocatalysis. The introduction of hydrophilic segments into the main-chain of polymer photocatalysts allows water to efficiently enter the interior through these hydrophilic segments, and results in effective water/polymer interfaces for hydrogen evolution. [ABSTRACT FROM AUTHOR]