Search

In the present experimental work, two identical real field experimental setups (with dry soil and wet soil) of ground-air heat exchanger (GAHE) have been developed in order to evaluate the influence of change in inlet air temperature, airflow velocity, diameter of pipe and soil moisture content on the thermal performance of GAHE system. Influence of these parameters on the required pipe length to produce a specified drop in air temperature has also been investigated. Results reveal that the drop in air temperature achieved from GAHE having dry soil is 11.2 °C at 60 m pipe length, whereas, for GAHE with wet soil having 20% moisture, the same amount of drop in air temperature is obtained at a pipe length of 28 m only. Moreover, upon increasing the airflow velocity from 2 m/s to 10 m/s, cooling capacity of GAHE with dry soil, wet soil with 5% moisture and wet soil with 20% moisture increases by 122%, 185% and 220%, respectively, after 6 h of operation, but the effectiveness of the GAHE system with dry soil, wet soil with 5% moisture and wet soil with 20% moisture decreases by 55.4%, 42.5% and 36.2%, respectively. • Development of an outfield experimental set up for GAHE system with dry and wet soil. • 53% length of GAHE pipe can be reduced by using wet soil with 20% moisture. • By increasing air flow velocity 2 m/s to 10 m/s, cooling capacity increases 220% in wet soil. • By increasing air flow velocity 2 m/s to 10 m/s, effectiveness decreases 36.2% in wet soil. • Required length of GAHE pipe highly depends on soil moisture, air velocity and pipe diameter. [ABSTRACT FROM AUTHOR]

Thermal performance of ground-air heat exchanger (GAHE) depends on the rate of heat transfer between air and soil, which is governed by thermal properties of soil surrounding the GAHE pipe. Soil thermal properties around GAHE pipe can be improved either by increasing its moisture contents or by using some thermally enhanced backfilling materials. In the present study experimentally investigates the thermal performance of ground-air heat exchanger system using a sand-bentonite mixture (dry as well as wet) and compare their performance with the ground air heat exchanger system having native soil (dry as well as wet) as backfilling material. The study acknowledges the highest cooling capacity (125 W) for GAHE with wet sand-bentonite as backfilling material, and after 6 h of continuous operation, it is 38.4%, 18.4% and 11.1% higher than that obtained with dry native soil, dry sand-bentonite and wet native soil, respectively. The study also revealed that thermal performance deterioration factor (TPDF) increases with the duration of the operation. At airflow velocity of 5 m/s, after 6 h of continuous operation highest TPDF is noticed for ground-air heat exchanger with dry soil (0.22); whereas, lowest TPDF is observed for ground-air heat exchanger system with wet sand-bentonite (0.07). Schematic of laboratory experimental setup of GAHE system. Image 1 • Development of a laboratory scale experimental set up for GAHE system. • To evaluate the effect of sand-bentonite backfilling material (dry as well as wet) on performance of GAHE system. • Maintaining a certain level of moisture into the soil in the close vicinity of GAHE pipe. • Better thermal performance of GAHE due to BFM resulting reduction in required pipe length. [ABSTRACT FROM AUTHOR]

• Development of a laboratory scale experimental set up with slinky-coil pipe layout. • Use of sand–bentonite mixture as backfilling material for GAHE system. • Required length of the trench is reduced by using slinky-coil pipe layout. • Substantial saving in terms of excavation cost and piping cost. The ground-air heat exchanger (GAHE) is the promising passive technique for building heating/cooling, but due to its high installation cost (mainly pipe cost and excavation cost), it could not become popular. The required length of pipe can be reduced by using thermally enhanced backfilling material (BFM), while, the length of the trench can be reduced by using slinky-coil pipe layout. In the present study, an experimental laboratory setup of GAHE system has been developed with a slinky-coil pipe layout and sand-bentonite as BFM. For this, a flexible PVC pipe of 75 mm diameter and 30 m length, has been arranged in slinky-coil pattern and installed horizontally in a soil box of 10.2 m length. For the study, variation in soil temperature (23 °C–27 °C), inlet air temperature (38 °C–46 °C), air flow velocity (5 m/s–20 m/s) and soil conditions (dry and wet), have been considered. Study reveals that a drop-in air temperature as high as 18.7 °C at 30 m pipe length (trench length of 10.2 m) can be achieved with soil at a temperature of 27 °C and inlet air temperature of 46 °C. The study also revealed that the pipe length could be reduced by 20% with wet sand-bentonite as compared to dry sand-bentonite. [ABSTRACT FROM AUTHOR]