Search

A 6 Gb/s 9.8 pJ/b rotatable non-contact connector applicable to industrial robot arms is developed. The proposed non-contact connector enables a high-speed and highly reliable wireless data connection between three-dimensional (3-D) cameras and an edge computer in an autonomously controlled robot. A rotatable transmission line coupler (RTLC) is proposed to accommodate the rotational operation of the robot arm. Since the proposed doughnut-shaped RTLC has a constant overlapped area at any rotation angle, the RTLC has a constant coupling gain at all rotation angles. To remove inter-symbol interference (ISI) occurring at a specific rotation angle, a pulse-equalizing receiver is also developed. An interface bridge IC is proposed to transfer a wide range of interface signals from a slow-control signal such as the control area network (CAN) to a high-speed video interface signal. A signal protocol conversion technique applying on-off keying (OOK) modulation is also developed in order to transfer slow legacy interfaces used in the robot arms that include a dc component. Experiments with a test chip fabricated in a 40 nm CMOS process confirmed that bit error rate (BER) was lower than 10 $^{-12}$ at any rotation angle in a communication distance of 3 mm. The proposed system improves energy efficiency by a factor of 3.7, area efficiency by a factor of 1.8. [ABSTRACT FROM AUTHOR]

A non-contact interface for modular smartphones that can provide a data connection at a maximum MIPI rate of 6 Gb/s has been developed. A two-fold transmission line coupler, which is a small-size coupler that has a wide bandwidth, is proposed for modular smartphones, where the layout area is strictly limited. The coupler size is 6 mm2 for a 5 mm communication distance, which is 1/24 smaller than the conventional coupler. Since many wireless communication components, such as LTE, WiFi, and GPS transceivers, are assembled in a small module, the interference between the non-contact interface and the wireless transceivers should be suppressed. To improve noise immunity and reduce unwanted radiation from the coupler, an electromagnetic-compatibility robust pulse transceiver is proposed. A synchronous receiver using an edge counting clock recovery circuit improves noise immunity, and a bi-phase pulse transmitter reduces noise radiation in the GPS band. There is no EMS by LTE or WiFi signals on the data connection at BER < 10^-12 when the coupler is separated by a distance of 2 mm and no EMI on GPS signals at a separation of 10 mm. Compared with the state-of-the-art result, the highest energy efficiency (6 pJ/b) and space efficiency (1.2 \textmm^2/1 \textmm distance) is achieved. [ABSTRACT FROM PUBLISHER]

A highly reliable wireless solid-state drive (SSD) system for future applications of large volume storage is presented. The wireless interface in the system consists of an inductively coupled power link with fast transmission power control and high-speed data links using transmission line couplers (TLCs). The wireless power link can deliver 1 W from the host to the SSD. The full duplex wireless data interface achieves raw data rate of 1.6 Gb/s. The reliability of the wireless interface is studied though simulation analysis and experiments. The error correction block for the NAND flash memory system can also correct errors in the wireless data links, allowing the requirements for the PHY layer to be relaxed. The error correction code is discussed, including optimization by analyzing the error bits on the wireless data links. The experimental results confirmed strong tolerance to the interference from the power link on the wireless data link, and the water proof property of both the data and power links. [ABSTRACT FROM PUBLISHER]