Search

Experimental tests of cross-laminated timber (CLT)-concrete composite floor panels were conducted. The tests consisted of linear-elastic tests of square CLT-concrete composite panels with a novel shear connector to determine elastic orthotropic plate properties. After the linear-elastic tests, the panels were subjected to a patch load at the center of the panel and tested to failure. To investigate load transfer across longitudinal joints between adjacent panels, nonuniform bending tests were conducted. Results from the experimentally measured orthotropic plate properties showed that the shear connector increased the bending stiffness in the weak direction of the panel compared to prior test results using conventional shear connectors. The tests to failure exhibited larger differences in behavior between the strong and weak orientations of the specimens, with both showing substantial inelastic behavior prior to failure. Numerical finite element models of the patch-load test showed good agreement with experimental results. Analytical formulas using the obtained orthotropic plate properties did not agree with experimental results for the patch-load at linear scales, suggesting the simplified method is currently not suited for CLT-concrete two-way bending. Load-transfer tests found that the reinforced concrete topping is capable of transferring load across the longitudinal joint of two parallel panels to enable two-way bending of composite timber–concrete floors and that the addition of a plywood spline with closely spaced screws enables a higher degree of force transfer. [ABSTRACT FROM AUTHOR]

Mass timber construction has seen a growing interest in North America and worldwide. In the US, code provisions allow mass timber buildings to be up to 82 m tall, but with floor slabs requiring a noncombustible, usually cementitious, topping over mass timber panels (MTPs). Designing the MTP and concrete topping to act compositely can increase the strength and stiffness compared to noncomposite MTP floors. Several connections are available to create composite action between an MTP and a concrete topping, with self-tapping screws being the most widely considered practice. A new test fixture and testing method were developed to characterize connection properties and facilitate the selection of fasteners most suitable for developing composite action. Three conventional self-tapping screws were experimentally investigated at the single-fastener scale. The screws were subjected to withdrawal at 90° and 45° orientations to the interface plane between the MTP and concrete. Withdrawal from both the MTP substrate and concrete topping was investigated. Three MTP materials were tested: cross-laminated timber (CLT) consisting of two different wood species and a mass ply panel (MPP). Results demonstrated that the pullout failure of the screwhead from the concrete was the limiting failure mode. Comparisons were made between the experimental results and analytical models for screw withdrawal to assess the applicability of available models to the different MTPs. These models underestimated the capacity of the tested fasteners for all samples except for the fully threaded screws. [ABSTRACT FROM AUTHOR]

This paper presents the behavior of floor diaphragms of a shake-table experiment of a full-scale 2-story mass-timber building structure. The structure consists of glued-laminated timber beams and columns, and floors and walls were designed and built making use of cross-laminated timber panels. Two different floor systems were designed, where the roof consists of a topped cross-laminated timber (CLT)-concrete composite system, and the floor level consists of untopped CLT panels connected with plywood single-surface splines. The CLT floor systems were designed to remain essentially elastic over the whole series of shake-table tests, which included testing of three lateral force–resisting systems tested at three different seismic intensity levels (service level, design basis, and maximum considered earthquake) for a total of 34 shake-table earthquake tests. Results from the testing indicate that CLT diaphragms designed to remain essentially elastic based on basic principles of structural mechanics and existing test data can achieve desired seismic performance objectives. In addition, sources of overstrength in certain elements of the diaphragm need to be explicitly considered for a holistic diaphragm design. [ABSTRACT FROM AUTHOR]