Search

The generation of abrasive particles is an unavoidable consequence of sliding electrical contact wear in conductive slip rings (SRs). The adhesion of abrasive particles to the insulators may lead to a decrease in flashover voltage, posing a risk to satellite power transmission. In this paper, the effect of abrasive particles on flashover is first studied. Surface abrasive particles can distort the surface electric field of the dielectric, absorb scattered electrons, and then re-emit them, thereby accelerating the development and formation of secondary electron avalanches. Flashover test results indicate that surface abrasive particles lead to a significant reduction in flashover voltage. To mitigate the impact of particle adhesion on flashover, a method of constructing particle traps on the surface of insulators is proposed. The location and structural parameters of the particle trap are further optimized and determined. The flashover test results using planar dielectric samples and SR insulator samples both demonstrate that the optimized particle trap can significantly improve the flashover voltage. The dielectric maintains high electrical strength even when particles are trapped in particle traps. The physical details of the impact of particles on flashover and the effect of particle traps are analyzed utilizing an electron movement simulation, corroborating the experiment from a microscopic aspect. [ABSTRACT FROM AUTHOR]

Frequency Domain Spectroscopy (FDS) is a powerful tool to study the dielectric properties of oil-paper insulation, which is widely used under high electric field strength. The motion of charge carriers under high electric field strength will cause new dielectric characteristics in FDS curves, from which more information could be extracted for insulation state assessment. In this paper, FD spectra are measured under high electric field strength. The electric field dependence of the loss peak in middle frequency and the characteristics of dielectric loss in low frequency are studied. With the influence of trapping on the motion of charge carriers under electric field being considered, charge carriers hopping polarization model and charge carriers motion dependent conductance model are proposed. The trap energy level of oil-paper insulation decreases when the moisture content increases, thus, the motion characteristics of charge carriers change, leading to decreasing loss peak in middle frequency and inverse dielectric loss characteristics in low frequency. These two models introduce the influence of traps on carrier motion into the dielectric response and enable one to gain a better understanding of the dielectric properties of oil-paper insulation under high electric field strength. [ABSTRACT FROM AUTHOR]

Epoxy‐impregnated paper transformer bushings are prone to water absorption due to the presence of water‐attracting moieties in the cellulose chemical structure and epoxy resin, leading to moisture‐induced insulation defects. To understand the mechanism of moisture's impact on epoxy‐impregnated paper, this study developed a testing platform that integrated moisture diffusion, adsorption, and dielectric properties of insulating materials. Insulation specimens made of epoxy resin and epoxy‐impregnated paper were prepared and their water diffusion characteristics were investigated using the Fick diffusion model and the Langmuir model, respectively. The Guggenheim–Anderson–de Boer equation was used to examine the vacuum vapour adsorption characteristics of the materials, providing a theoretical foundation for examining the form of water present within them. The dielectric response of materials with varying moisture levels was then tested to study the effect of water on the dielectric spectrum curve. Using the Extended Derivative Method, the characteristic frequency reflecting the water content of the epoxy‐impregnated paper was extracted. The results demonstrate that 0.01‐Hz characteristic frequency provides superior accuracy for moisture assessment in epoxy resins compared to 50 Hz, and extracting and fitting the relaxation peak characteristic frequency in epoxy‐impregnated paper moisture evaluation yields higher accuracy than using tan δ at the power frequency. [ABSTRACT FROM AUTHOR]

Frequency Domain Spectroscopy (FDS) is widely used to estimate oil–paper insulation. The high moisture and long aging change the FDS characteristics of the insulating oil–paper, so normalization processing is required. Still, the choice of single activation energy needs further research. This paper studies the FDS characteristic of oil–paper insulation samples with different moisture and aging degrees and improves the traditional temperature correction method. The enhanced Arrhenius model uses the segmented activation energy to make the normalized FDS curve coincide better with the target curve, and the error is reduced. In addition, to verify the method's effectiveness, this paper proposes an iterative correction process. It corrects the tan δ-f curve of the bushing with an aging time of 800 h based on segmented activation energy, and the overall normalization effect is improved. [ABSTRACT FROM AUTHOR]

Atmospheric pressure dielectric barrier discharge (DBD) has abundant application fields, and the influence of the barrier material on DBD characteristics has been the research focus in recent years. In this work, a two-dimensional fluid model is built to investigate the effects of the barrier dielectric surface layer with different permittivity distribution on DBD, including electric parameters, electron distribution, and surface charge evolution. It is demonstrated that higher dielectric permittivity can affect DBD by enhancing the electric field Espace of space charge and weakening electric field Esurf of the surface charge and have a more obvious influence on Esurf, which can make DBD transform from glowlike discharge to streamerlike discharge. The dielectric surface layer with linear distribution of permittivity is introduced in DBD, changing the discharge appearance and discharge channel forming sequence. This work may provide some theoretical experiences for the application of a functionally graded material as a barrier dielectric in DBD. [ABSTRACT FROM AUTHOR]

In this work, samples of oil-immersed paper with different moisture levels and aging condition were studied. Frequency domain spectroscopy (FDS) of the samples was examined at 40 °C under different excitation voltages. A non-linear phenomenon in frequency domain dielectric response with different moisture contents and aging condition was observed. The non-linear phenomenon appears to be related to the hindrance effect of cellulose on the movement of ions and the Poole-Frenkel effect on the concentration of ions. With aging, the nonlinear loss peaks at different frequencies caused by the effect of nonlinear conductance and interface polarization appear in the FDS results. The non-linear phenomenon was modeled and verified experimentally. The characteristic parameters and quantitative method to estimate moisture content and the degree of aging degree of oil-immersed paper can be obtained by the proposed method. [ABSTRACT FROM AUTHOR]

The discharge mode transitions and the characteristics of atmospheric pressure dielectric barrier discharge in pure helium (He-DBD) are studied. Different discharge modes of He-DBD are clarified, including filament-diffuse mixed mode, filamentary mode, diffuse mode, and multichannels coupled mode. The transitions of different modes are explored by changing the gap width and applied voltage. According to the luminous structure of discharge [short exposure (100~300 ns) image], it is found that there should be only Townsend-like and glow-like discharges that appear in the above modes. In Townsend-like discharge, the secondary electron emission coefficient (SEEC) of dielectric is estimated. Based on which, a fluid model coupled with an external circuit is built to explain the He-DBD mode transitions mechanism and the applied voltage drop’s influence on He-DBD. Through the temporal evolution of a luminous structure, a discharge filament is believed to be a contractive state of discharge channel, which should be an unstable glow-like discharge. The radius of discharge channel, changing with gap width and applied voltage, is measured. The discharge contraction is attributed to the nonlinear relationship between Townsend ionization coefficient and electric field. The enhancing interaction between different discharge channels inhibits the appearing of diffuse discharge around discharge filament, leading to the transition from mixed mode to filamentary mode. In the end, the multichannels coupled mode is proven to be glow-like discharge, and its formation mechanism is explained by the overlap of discharge channels. [ABSTRACT FROM AUTHOR]

In order to realize the diagnosis of water distribution, this paper analyzes the interface polarization and macroscopic space charge polarization mechanism when the water distribution is non-uniform. The experimental results of this paper and bushing show that when the moisture distribution is non-uniform, there is a significant loss peak in the tanδ-f curve. The loss peak shifts to higher frequencies as the non-uniformity coefficient increases. There are common intersection points between multiple tanδ-f curves. Further, this paper realizes the diagnosis of the location of moisture distribution through Frequency Domain Spectroscopy (FDS) testing of different voltages and different wiring methods based on the macroscopic space charge polarization. In the single-cycle FDS test, when the positive electrode is first added to the area with higher moisture content, the amplitude of the tanδ-f curve is smaller. The tanδ-f curves under different wiring methods constitute a "ring-shaped" loss peak. As the voltage increases, the peak value of the loss peak shifts to the lower frequency band. As the temperature increases, the peak value of the loss peak shifts to higher frequencies. Based on the above rules and mechanism analysis, this research provides a new solution for the evaluation of moisture content of oil-immersed polymers equipment. [ABSTRACT FROM AUTHOR]