Search

This paper identifies possible topological reconfigurability of a T-type inverter for direct torque controlled (DTC) induction motor drives when an open-switch fault occurs. In open-switch fault, inverter current path is different than normal path. This causes undesirable inverter switching states. Since DTC is based on a voltage vector selection criterion, open-switch fault causes ambiguous torque control. Analysis of DTC drive under two different inverter open-switch fault conditions viz. half-bridge and neutral-point switch fault are presented. The operation of the inverter in DTC mode against faults is achieved by simple topological reconfiguration. [ABSTRACT FROM PUBLISHER]

This paper presents an improved direct torque control (DTC) method for an asymmetrical six-phase induction motor using a two-level six-phase inverter. As is well known, a simple extension of three-phase DTC technique to an asymmetrical six-phase motor, using large vectors only, introduces significant current harmonics of the order 6 n±1 (n = 1, 3, 5,…), which are mapped into the nonflux/torque producing (xy) plane. These harmonics cause only losses in the motor winding as they do not take part in torque production. Hence, a number of different improved DTC techniques have been developed in the past for multiphase motor drives. The paper takes one such DTC method as the starting point and improves it further by using the concept of virtual voltage vectors. Developed vector selection algorithm, based on two virtual voltage vectors, requires the information on position of the flux in the auxiliary (xy) subspace and provides stator current quality commensurate with the currently available best DTC algorithm for six-phase drives. However, use of two virtual voltage vectors enables a substantial reduction of the torque ripple, which is achieved by means of a five-level torque comparator. Extensive experimentation is performed and it is shown that the reduction of the current harmonics is in essence almost the same as in another recently developed DTC scheme, based on the use of a single virtual voltage vector. However, the achieved torque ripple reduction, which is verified experimentally, makes the scheme superior when compared to the existing approaches. At the same time, developed scheme retains qualities of conventional DTC schemes, such as simple structure and fast response. Its additional beneficial feature is the easiness of implementation. [ABSTRACT FROM PUBLISHER]

In this paper, the direct torque control (DTC) for a three-level five-phase inverter-fed five-phase induction motor is proposed to improve the low-speed performance. The classical DTC scheme (DTC-I) is modified in order to minimize the demagnetization effect during a low-speed operation. According to the modification, the voltage vector space plane is divided into 20 sectors, each of sector 18°. For odd number of sectors, ${{\pm 36^\circ }}$ displaced intermediate voltage vectors, and for even number of sectors, ${{\pm 36^\circ }}$ displaced main voltage vectors are selected instead of classic ${{\pm 72^\circ }}$ displaced voltage vectors. The zero voltage vectors are omitted in the proposed DTC scheme (DTC-II) for the low-speed operation. The DTC-II scheme reduces the demagnetization effect during a low-speed region at the cost of increase in the torque ripple due to avoiding zero voltage vectors. As the speed ramps up, the ${{\pm 72^\circ }}$ displaced voltage vectors are selected through a seven-level torque comparator and are divided into ten sectors. Therefore, in the medium and the higher speed region, the torque ripple is reduced by using the seven-level torque comparator. Simulation and experimental results are presented in order to validate the DTC-II method. [ABSTRACT FROM PUBLISHER]