Search

The paper discusses the concept of a mini custom power park in which the voltage inside the park is tightly regulated by a distribution static compensator (DSTATCOM). It will be shown on the basis of simulations with ideal components that solid state protection devices, along with the DSTATCOM will eliminate many transients in all the loads of the park during disturbances. Moreover, the DSTATCOM, backed by a diesel generator, will supply the most sensitive loads during the total line outages, thereby nearly making them both transient and interruption free. In this paper, a configuration of the park is proposed and then various issues involved with the operation of the park are discussed. The proposed operation of the custom power park is verified through extensive digital computer simulation studies. [ABSTRACT FROM AUTHOR]

In this paper, the performance of voltage-source converter-based shunt and series compensators used for load voltage control in electrical power distribution systems has been analyzed and compared, when a nonlinear load is connected across the load bus. The comparison has been made based on the closed-loop frequency response characteristics of the compensated distribution system. A distribution static compensator (DSTATCOM) as a shunt device and a dynamic voltage restorer (DVR) as a series device are considered in the voltage-control mode for the comparison. The power-quality problems which these compensator address include voltage sags/swells, load voltage harmonic distortions, and unbalancing. The effect of various system parameters on the control performance of the compensator can be studied using the proposed analysis. In particular, the performance of the two compensators are compared with the strong ac supply (stiff source) and weak ac-supply (non-stiff source) distribution system. The experimental verification of the analytical results derived has been obtained using a laboratory model of the single-phase DSTATCOM and DVR. A generalized converter topology using a cascaded multilevel inverter has been proposed for the medium-voltage distribution system. Simulation studies have been performed in the PSCAD/EMTDC software to verify the results in the three-phase system. [ABSTRACT FROM AUTHOR]

In this paper, a generalized multiband hysteresis modulation and its characterization have been proposed for the sliding-mode control of cascaded H-bridge multilevel-inverter (CHBMLI)-controlled systems. A frequency-domain method is proposed for the determination of net hysteresis bandwidth for a given desired maximum switching frequency of the inverter. The switching transition concept of Tsypkin's method and the describing function of nonlinear relay have been used for the derivation of results. A hierarchical switching algorithm has been suggested for the modular cells of the cascaded multilevel inverter. The hierarchy of each cell is swapped sequentially to provide the self-balancing capability in case the dc-link voltage is supported by the capacitors. The simulation and experimental verification of the derived results are provided through a single-phase distribution static compensator (DSTATCOM) model. The application in the three-phase system has been shown through simulation studies on a 3.3-kV distribution-system compensation using DSTATCOM. Verification on both single- and three-phase systems is obtained using a five-level cascaded-multilevel-inverter topology. [ABSTRACT FROM AUTHOR]

In this paper, a fixed-switching-frequency closed-loop modulation of a voltage-source inverter (VSI), upon the digital implementation of the modulation process, is analyzed and characterized. The sampling frequency of the digital processor is considered as an integer multiple of the modulation switching frequency. An expression for the determination of the modulation design parameter is developed for smooth modulation at a fixed switching frequency. The variation of the sampling frequency, switching frequency, and modulation index has been analyzed for the determination of the switching condition under closed loop. It is shown that the switching condition determined based on the continuous-time analysis of the closed-loop modulation will ensure smooth modulation upon the digital implementation of the modulation process. However, the stability properties need to be tested prior to digital implementation as they get deteriorated at smaller sampling frequencies. The closed-loop modulation index needs to be considered maximum while determining the design parameters for smooth modulation. In particular, a detailed analysis has been carried out by varying the control gain in the sliding-mode control of a two-level YSI. The proposed analysis of the closed-loop modulation of the VSI has been verified for the operation of a distribution static compensator. The theoretical results are validated experimentally on both single- and three-phase systems. [ABSTRACT FROM AUTHOR]

This paper examines the application of a diodeclamped multilevel inverter (DCMLI).based distribution static compensator (DSTATCOM) connected to a three-phase, four-wire (3p4w) distribution system. The DCMLI has an inherent unbalancing problem among its dc capacitor voltages. Additionally, when the load contains a dc part, the neutral point of the compensator also becomes unbalanced. In this paper, the effects of different loading conditions on the dc capacitor voltages of the inverter are studied. Two new control circuits are proposed for equalizing the capacitor voltages. Different control techniques are presented for the equalizing circuits. Equations of the proposed equalizing controllers are developed corresponding to the control of the switching devices. Comparative studies of different control techniques and the performances of the two controllers are performed. Simulation studies are performed using PSCADIEMTDC to validate the efficacy of the proposed equalizing controller circuits. [ABSTRACT FROM AUTHOR]

In this paper, the method of triangular carrier switching control of two-level inverters is extended to cascaded multilevel inverters using phase-shifted multicarrier unipolar pulsewidth modulation (PWM). The condition for smooth modulation is obtained using the Bessel's function representation of the PWM output and the switching condition of the multilevel- inverter-controlled system. A method is proposed for the determination of the minimum amplitude of the triangular carrier for smooth modulation at fixed switching frequency. It is shown that the multilevel modulation based on the phase-shifted carriers significantly reduces the ripple magnitude in the switching function and allows the use of a smaller carrier amplitude under closed loop. This increases the forward gain and, hence, improves the tracking characteristics. The proposed cascaded multilevel inverter control is implemented for the operation of a distribution static compensator (DSTATCOM) in the voltage control mode. The experimental verification of the theoretical and simulation results is provided through a field-programmable gate array (FPGA) based control of a laboratory model of a single-phase DSTATCOM. [ABSTRACT FROM AUTHOR]

In this paper, load compensation using multilevel inverter-based distribution static compensator (DSTATCOM) is presented. The DSTATCOM is connected to a three-phase four-wire (3p4w) distribution system. Two different multilevel inverter topologies are used to realize the DSTATCOM. They are diode-clamped multilevel inverter (DCMLI) and flying capacitor multilevel inverter (FCMLI). A compensating technique has been derived, which uses the state feedback control to the multilevel inverters-based DSTATCOMs. A switching strategy for the multi-level inverters that ensures utilization of all output voltage states of the inverter for efficient tracking of references has been proposed. The schemes of dc-link capacitor volthge control for DCMLI and flying capacitor voltage control for FCMLI have been discussed. Comparative studies of performances of the two DSTATCOM topologies are performed. The simulation studies are performed using PSCAD/EMTDC to validate the efficacy of the proposed control scheme. [ABSTRACT FROM AUTHOR]

Flying capacitor multilevel inverter (FCMLI) is a multiple voltage level inverter topology intended for high voltage and power operations with low distortion. It uses capacitors, called flying capacitors for clamping the voltage across the power semiconductor devices. In this paper, the implementation of a distribution static compensator (DSTATCOM) using an FCMLI is presented. A hysteresis current control technique for controlling the injected current by the FCMLI-based DSTATCOM is discussed. A new method for controlling the flying capacitor voltages is proposed which ensures that their voltages remain constant and at the same time maintain the desired current profile under the hysteresis current control operation. Simulation studies are performed using PSCAD/EMTDC to validate the efficacy of the control scheme and the FCMLI-based DSTATCOM. [ABSTRACT FROM AUTHOR]