Search

This research study explains the design and performance of a Static VAR Compensator (SVC) coupled Hybrid Distribution Static Compensator (DSTATCOM) for low voltage power distribution system (PDS). A comparative analysisis done between Voltage Source Inverter (VSI)-based DSTATCOM and SVC Hybrid DSTATCOM using Jordan Least Mean Square (JLMS) algorithm to alleviate the shunt-related power quality (PQ) glitches. The specific design is obtained as compared to the existing neural network toolbox algorithm to improve the estimation speed and accuracy. The main objective is to extract the tuned weighted values of fundamental active and reactive power components of distorted load currents for the switching signal generation using an adaptive JLMS algorithm.Several functions of DSTATCOM and hybrid DSTATCOM using this JLMS controller are showcased for harmonics curtailment, power factor (p.f.) improvement, load balancing, voltage regulation, etc. Simulation results on an SVC Hybrid DSTATCOM have shown an acceptable level of performance under unbalanced loading situations. Finally, some comparative results are provided to validate the feasibility and effectiveness of the suggested topology.

This article demonstrates the performance of back-to-back connected voltage source inverter (BTB-VSI)-based distribution static compensator (DSTATCOM). In the proposed system, a three-phase three wire electrical utility system (EUS) is integrated with distributed energy resources (DER) through BTB-VSI. It has drawn more attention due to enhanced active power filtering, simple design procedure and performs reliable operation. The objectives of the research work is to provide clean power for weak EUS with improved power quality (PQ) such as, better voltage regulation, improved power factor (P.F), reduced total harmonic distortion (THD), balanced voltage at point of common coupling (PCC) and better optimal active power flow control (OAPFC), and so on. An artificial neurocontrol technique Kernel Hebbian Least Mean Square (KHLMS) is chosen to determine the accurate reference source current for operation of voltage source inverter (VSI). The BTB-VSI performance is investigated on both shunt compensation and OAPFC. The proposed system is converted to a simulation model and hardware unit using MATLAB/Simulink software and SPARTAN−6 field programmable gate arrays (FPGA) controller. Finally, the Simulation and experimental results illustrate that the shunt compensating ability with OAPFC of BTB-VSI performs better over VSI as per IEEE Std 1159–2019 grid code. [ABSTRACT FROM AUTHOR]

This paper presents the shunt compensation performance of quasi-Z-source inverter (QZSI) and back to back connected QZSIs (BB-QZSI) to address the power quality (PQ) issues in the three-phase three-wire power utility network (PUN). Generally, these PQ issues are poor voltage regulation, low power factor (PF), source current distortion, unbalanced voltage, etc. The proposed BBQZSI-based distribution static compensator (DSTATCOM) consists of two QZSIs with a common dc-link capacitor. Because the QZSI could achieve buck/boost conversion as well as DC to AC inversion in a single-stage and the back to back configuration decreases the system down time cost (if a fault occurs in one QZSI the other can continue the shunt compensation). Particularly, icos ϕ control algorithmcontrol algorithm is implemented to generate proper switching pulses for the switches of DSTATCOM. The effectiveness of the BB-QZSI is verified through simulation studies over QZSI using MATLAB/Simulink software satisfying the recommended grid code.

With the rapid advancement of the technology, deep learning supported voltage source converter (VSC)-based distributed static compensator (DSTATCOM) for power quality (PQ) improvement has attracted significant interest due to its high accuracy. In this paper, six subnets are structured for the proposed deep learning approach (DL-Approach) algorithm by using its own mathematical equations. Three subnets for active and the other three for reactive weight components are used to extract the fundamental component of the load current. These updated weights are utilised for the generation of the reference source currents for VSC. Hysteresis current controllers (HCCs) are employed in each phase in which generated switching signal patterns need to be carried out from both predicted reference source current and actual source current. As a result, the proposed technique achieves better dynamic performance, less computation burden and better estimation speed. Consequently, the results were obtained for different loading conditions using MATLAB/Simulink software. Finally, the feasibility was effective as per the benchmark of IEEE guidelines in response to harmonics curtailment, power factor (p.f) improvement, load balancing and voltage regulation.

This article proposes an adaptive Kernel-Hebbian least mean square (KHLMS) controller for a dual voltage source inverter (VSI). The recommended topology consists of a distributed energy resource (DER) supported VSI called main VSI (MVSI) and split capacitor supported VSI termed as auxiliary VSI (AVSI). Both the MVSI and AVSI are used to serve the shunt compensation when DER is not integrated with MVSI. The DER scenario is considered to suppress the active power flow shortage in the utility grid. Here, optimal active power flow control (OAPFC) is managed by MVSI and shunt compensation is achieved by AVSI during DER operated mode. Hence, a dual VSI based distribution static compensator (DSTATCOM) facilitates the configuration merits such as reduction in system downtime cost, filter rating switching stress etc. Supremacy of both the neural network (NN) based controller and topology is presented by comparing VSI (called AVSI) in the context of harmonic reduction in source side, voltage balancing, power factor (PF) enhancement, better voltage regulation and OAPFC. The experimental results are obtained through field programmable gate array (FPGA) based hardware units which exhibit radical improvement in the power quality (PQ) conferring as per the international standard grid code (IEEE-519-2017). [ABSTRACT FROM AUTHOR]

The requirement of a robust and adaptive control algorithm in active filters is inevitable nowadays. In this paper, an ADAptive LINEar neuron (ADALINE) based Least Mean Square (LMS) control algorithm is proposed for a three-phase-four-wire (3P4W) distribution power system under unbalanced loading conditions. The proposed controller has a unique inbuilt characteristic to extract the fundamental active positive sequence component from an unbalanced load current. Particularly, the control algorithm is intended to calculate an adaptive and suitable amplitude for the three-phase reference source currents which are used for the switching pulse generation in the subsequent steps. Moreover, the Distribution STATic COMpensator (DSTATCOM) is performed to eliminate harmonic contents of supply current and harmful excessive neutral current in the system. Further, the DC-link voltage is regulated in order to reduce the power loss across the DSTATCOM, and to attain a balanced, high-quality power availability at the Point of Common Coupling (PCC). The proposed system is accomplished in the MATLAB2014a/Simulink, and a low power rated 3P4W DSTATCOM prototype incorporating with the dSPACE1104 real-time environment to verify the proposed control algorithm. [ABSTRACT FROM AUTHOR]

This research work introduces a new hybrid technique called quasi‐Newton back‐propagation based i cosϕ control algorithm. Its structure is constructed on the concept of biological features like input neuron, target neuron, weight correction and more attractive due to its parallel computing, learning capability behaviour. Systematic step‐by‐step procedures are represented by mathematical equations in the MATLAB/Simulink platform. The fundamental weighted values of active and reactive power components of load currents are extracted using the proposed control technique to generate the reference source currents. Further, the reference source currents are used to generate switching pulses for voltage source converter (VSC) of the distributed static compensator (DSTATCOM). It is capable enough to perform several functions such as harmonic mitigation, power factor correction, load balancing and voltage regulation which further reduce the DC link voltage across the self‐supported capacitor of the VSC. Simulation and experimental validation demonstrates better performance of the suggested algorithm for operation of the DSTATCOM at different loading conditions. [ABSTRACT FROM AUTHOR]