Search

Scaffolding is equipment usually used at construction sites. A scaffolding structure is lightweight and made of elements used many times. The characteristics of scaffolding make it susceptible to dynamic actions present at the structure or occurring nearby. A scaffolding structure of medium size was subjected to analysis in this paper. The structure FEM model was loaded with single force harmonic excitation with various frequencies ranging from 1 Hz to 12 Hz applied in one of many selected points on the scaffolding façade. In the first step, natural frequencies and mode shapes of the analyzed structure were calculated. Then the full dynamic analysis was carried out to obtain maximum displacements of selected control points. The relation of excitation force frequency and location to the amplitudes of generated displacement was observed. It was found that low excitation frequencies close to the natural frequencies of the structure produced vibrations ranging to large areas of the scaffolding surface. Higher excitation frequencies are usually less propagated at the scaffolding but still may produce some discomfort to the structure users in the vicinity of the excitation force location. Scaffolding is equipment usually used at construction sites. A scaffolding structure is lightweight and made of elements used many times. The characteristics of scaffolding make it susceptible to dynamic actions present at the structure or occurring nearby. A scaffolding structure of medium size was subjected to analysis in this paper. The structure FEM model was loaded with single force harmonic excitation with various frequencies ranging from 1 Hz to 12 Hz applied in one of many selected points on the scaffolding façade. In the first step, natural frequencies and mode shapes of the analyzed structure were calculated. Then the full dynamic analysis was carried out to obtain maximum displacements of selected control points. The relation of excitation force frequency and location to the amplitudes of generated displacement was observed. It was found that low excitation frequencies close to the natural frequencies of the structure produced vibrations ranging to large areas of the scaffolding surface. Higher excitation frequencies are usually less propagated at the scaffolding but still may produce some discomfort to the structure users in the vicinity of the excitation force location. [ABSTRACT FROM AUTHOR]

Scaffoldings are used for works at height and in places that are hard to reach, which makes such works dangerous to employees and accidents occur frequently. Loads generated by scaffolding users cannot be avoided. Moving workers excite low-frequency (1–2 Hz) vibrations and scaffoldings as slender structures are prone to such dynamic action. The method for determining the probability of vibrations excitation is presented here. The quantity representing this probability is called the predictor of occurrence of a dangerous situation due to vibrations induced by a walking employee. The predictor of resonance with ith natural frequency requires an analysis of the scaffolding dynamic behavior. The frequencies and the natural mode shapes of vibrations were determined. Numerical dynamic simulations of the worker's movement on the penultimate decks of two scaffoldings were carried out, as well. Predictor analysis was made for single frequencies and combinations of frequency pairs. The predictor values calculated for the first frequency or combinations with it are the highest ones, however the probability of resonance is not only affected by the first frequency. To improve safety, the natural frequencies should be increased. For longitudinal vibrations, this can be done by adding more bracing or reducing lengths of anchors. Increasing the number of anchors gives good results in both directions. During scaffolding design of both typical and atypical constructions, one must determine the natural frequencies and then, if the first natural frequency is less than 4.0 Hz, perform a dynamic scaffolding analysis. [ABSTRACT FROM AUTHOR]