Search

We investigated the effects of the propagation path and site amplification of shallow tremors along the Nankai Trough. Using far‐field S‐wave propagation from intraslab earthquake data, the amplification factors at the DONET stations were 5–40 times against an inland outcrop rock site. Thick (∼5 km) sedimentary layers with VS of 0.6–2 km/s beneath DONET stations have been confirmed by seismological studies. To investigate the effects of thick sedimentary layers, we synthesized seismograms of shallow tremors and intraslab earthquakes at seafloor stations. The ratios of the maximum amplitudes from the synthetic intraslab seismograms between models with and without thick sedimentary layers were 1–2. This means that thin lower‐velocity (<0.6 km/s) sediments just below the stations primarily control the estimated large amplifications. Conversely, at near‐source (≤20 km) distances, 1‐order amplifications of seismic energies for a shallow tremor source can occur due to thick sedimentary layers. Multiple S‐wave reflections between the seafloor and plate interface are contaminated in tremor envelopes; consequently, seismic energy and duration are overestimated. If a shallow tremor occurs within underthrust sediments, the overestimation becomes stronger because of the invalid rigidity assumptions around the source region. After 1‐order corrections of seismic energies of shallow tremors along the Nankai Trough, the scaled energies of seismic slow earthquakes were 10−10–10−9 irrespective of the region and source depth. Hence, the physical mechanisms governing seismic slow earthquakes can be the same, irrespective of the region and source depth. Plain Language Summary: The deployment of campaigns and permanent ocean bottom seismometers (OBSs) has enabled us to investigate the activity and physical properties of offshore seismic phenomena. Our knowledge of offshore subsurface structures is still limited; consequently, many studies have used conventional analysis methods with the simplest assumptions. Using observed and synthetic seismograms near the Nankai Trough, we found a limitation in the conventional analysis method applied to OBS data. Thick sedimentary layers, which have been confirmed by seismological studies along the Nankai Trough just below the OBSs, cause an approximately 1‐order overestimation of source parameters for seismic phenomena occurring around the shallow plate boundary. This overestimation may have occurred during the seismic energy estimation of shallow slow earthquakes in Hikurangi, Costa Rica, and Mexico. After correcting for the effects of thick sedimentary layers, we found that the scaled energies of seismic slow earthquakes were 10−10–10−9 irrespective of the region and source depth. This suggests that the physical mechanisms governing seismic slow earthquakes can be the same, regardless of region and source depth. Key Points: Effects of path and site on the seismic energy estimation of slow earthquakes at shallow plate boundaries were investigatedThe assumption of far‐field body waves without thick sediments causes an overestimation of seismic energies for shallow tremorsScaled energies of seismic slow earthquakes at both shallow and large depths range from 10−10 to 10−9 [ABSTRACT FROM AUTHOR]

We present one of the first studies on source location determination for volcanic earthquakes and characterization of volcanic subsurfaces using data from a distributed acoustic sensing (DAS) system. Using the arrival time difference estimated from well-correlated waveforms and a dense spatial distribution of seismic amplitudes recorded along the fiber-optic cable, we determine the hypocenters of volcanic earthquakes recorded at Azuma volcano, Japan. The sources are located at a shallow depth beneath active volcanic areas with a range of approximately 1 km. Spatial distribution of the site amplification factors determined from coda waves of regional tectonic earthquakes are well correlated with old lava flow distributions and volcano topography. Since DAS observation can be performed remotely and buried fiber-optic cables are not damaged by volcanic ash or bombs during eruptions, this new observation system is suitable for monitoring of volcanoes without risk of system damage and for evaluating volcanic structures. [ABSTRACT FROM AUTHOR]

Stress accumulation and release inside the plate remains poorly understood compared to that at the plate boundaries. Spatiotemporal variations in foreshock and aftershock activities can provide key constraints on time‐dependent stress and deformation processes inside the plate. The 2017 M5.2 Akita‐Daisen intraplate earthquake in NE Japan was preceded by intense foreshock activity and triggered a strong sequence of aftershocks. We examine the spatiotemporal distributions of foreshocks and aftershocks and determine the coseismic slip distribution of the mainshock. Our results indicate that seismicity both before and after the mainshock was concentrated on a planar structure with N‐S strike that dips steeply eastward. We observe a migration of foreshocks toward the mainshock rupture area, suggesting the possibility that foreshocks were triggered by aseismic phenomena preceding the mainshock rupture. The mainshock rupture propagated toward the north, showing less slip beneath foreshock regions. The stress drop of the mainshock was 1.4 MPa, and the radiation efficiency was 0.72. Aftershocks were intensely triggered near the edge of large coseismic slip regions where shear stress increased. The aftershock region expanded along the fault strike, which can be attributed to the postseismic aseismic slip of the mainshock. We find that the foreshocks, mainshock, aftershocks, and postseismic slip released stress at different segments along the fault, which may reflect differences in frictional properties. Obtained results were similar to those observed for interplate earthquakes, which supports the hypothesis that the deformation processes along plate boundaries and intraplate faults are fundamentally the same. Key Points: Relocated hypocenters and focal mechanisms indicate that the mainshock, foreshocks, and aftershocks occur on the same intraplate faultThe foreshocks, mainshock, aftershocks, and postseismic slip released stress on different fault segmentsForeshock and aftershock seismicity migrate along the fault plane, suggesting that aseismic slip occurs before and after the mainshock [ABSTRACT FROM AUTHOR]

Recently, coda-wave interferometry has been used to monitor temporal changes in subsurface structures. Seismic velocity changes have been detected by coda-wave interferometry in association with large earthquakes and volcanic eruptions. To constrain the spatial extent of the velocity changes, spatial homogeneity is often assumed. However, it is important to locate the region of the velocity changes correctly to understand physical mechanisms causing them. In this paper, we are concerned with the sensitivity kernels relating travel times of coda waves to velocity changes. In previous studies, sensitivity kernels have been formulated for two-dimensional single scattering and multiple scattering, three-dimensional multiple scattering, and diffusion. In this paper, we formulate and derive analytical expressions of the sensitivity kernels for three-dimensional single-scattering case. These sensitivity kernels show two peaks at both source and receiver locations, which is similar to the previous studies using different scattering models. The two peaks are more pronounced for later lapse time. We validate our formulation by comparing it with finite-difference simulations of acoustic wave propagation. Our formulation enables us to evaluate the sensitivity kernels analytically, which is particularly useful for the analysis of body waves from deeper earthquakes. [ABSTRACT FROM AUTHOR]

We examined a relationship between rupture propagation directions and the distribution of fault strength by analyzing seismological data from the earthquake swarm on the Yamagata-Fukushima border, NE Japan. This earthquake swarm exhibits a distinct hypocenter migration behavior and was estimated to be triggered by upward fluid movement after the 2011 Tohoku-Oki earthquake. We utilized the dense nationwide seismic network in Japan to estimate apparent source time functions of >1500 small earthquakes (M JMA ≥ 2). We found clear directional dependences of the peak amplitude and the pulse-width in the apparent source time functions, suggesting the earthquake rupture directivity, for half of the earthquakes. Rupture directions mostly avoid the directions of the hypocenter migration. The difference between the microscopic and macroscopic propagations of rupture might be explained by the spatial variation in the fault strength affected by pore pressure along the fault; ruptures of each earthquake are hindered from developing toward the region with higher fault strength ahead of the pore-pressure front. Estimates of stress drop systematically increased on taking the effects of rupture directivity into account. We observed a temporal increase in stress drop from 3 MPa to 10 MPa during the pore-pressure migration. • Strength gradient caused by upwelling fluid controls each rupture in the swarm. • Estimates of stress drop systematically increased on taking the effects of rupture directivity into account. • Individual earthquakes share the common macroscopic plane structures in the swarm diffusion. [ABSTRACT FROM AUTHOR]