Search

The applied electrical fields required to initiate surface flashover of different types of dielectric material immersed in insulating oil have been investigated, by applying impulses of increasing peak voltage until surface flashover occurred. The behavior of the materials in repeatedly over-volted gaps was also analyzed in terms of breakdown mode (some bulk sample breakdown behaviour was witnessed in this regime), time to breakdown, and breakdown voltage. Cylindrical samples of polypropylene, low-density polyethylene, ultra-high molecular weight polyethylene, and Rexolite, were held between two electrodes immersed in insulating oil, and subjected to average applied electrical fields up to 870 kV/cm. Tests were performed in both uniform- and nonuniform- fields, and with different sample topologies. In applied field measurements, polypropylene required the highest levels of average applied field to initiate flashover in all electrode configurations tested, settling at ~600 kV/cm in uniform fields, and ~325 kV/cm in non-uniform fields. In over-volted point-plane gaps, ultra-high molecular weight polyethylene exhibited the longest pre-breakdown delay times. The results will provide comparative data for system designers for the appropriate choice of dielectric materials to act as insulators for high-voltage, pulsed-power machines. [ABSTRACT FROM AUTHOR]

Corona-stabilised plasma closing switches, filled with electronegative gases such as SF6 and air, have been used in pulsed-power applications as repetitive switching devices for the last 10 years. Their high repetition-rate capabilities coupled with their relatively simple design and construction have made them suitable alternatives to thyratrons and semi-conductor switches. As well as having repetitive switching capabilities, corona-stabilised plasma closing switches have the potential to operate at elevated voltages through the incorporation of multiple electrode sets. This allows high-voltage operation with inherent voltage grading between the electrodes. A further feature of such switches is that they can have relatively low jitter under triggered condition. This paper reports on some of the operational features of a new design of corona-stabilised, cascade switch that utilises air as the insulating gas. At pressures between 0 and 1 bar gauge the switch has be shown to operate over the voltage range of 40 to 100 kV with a jitter below 2 ns. [ABSTRACT FROM AUTHOR]

The applied electrical fields required to initiate surface flashover of different types of dielectric material immersed in insulating oil have been investigated, by applying impulses of increasing peak voltage until surface flashover occurred. The behavior of the materials in repeatedly over-volted gaps was also analyzed in terms of breakdown mode (some bulk sample breakdown behaviour was witnessed in this regime), time to breakdown, and breakdown voltage. Cylindrical samples of polypropylene, low-density polyethylene, ultra-high molecular weight polyethylene, and Rexolite, were held between two electrodes immersed in insulating oil, and subjected to average applied electrical fields up to 870 kV/cm. Tests were performed in both uniform- and non-uniform-fields, and with different sample topologies. In applied field measurements, polypropylene required the highest levels of average applied field to initiate flashover in all electrode configurations tested, settling at ∼600 kV/cm in uniform fields, and ∼325 kV/cm in non-uniform fields. In over-volted point-plane gaps, ultra-high molecular weight polyethylene exhibited the longest pre-breakdown delay times. The results will provide comparative data for system designers for the appropriate choice of dielectric materials to act as insulators for high-voltage, pulsed-power machines. [ABSTRACT FROM AUTHOR]