Search

Two key problems in meshed high-voltage direct current (HVDC) transmission grids are managing line power flows and protection against dc faults. Current flow controllers (CFCs) will be required to balance cable currents in meshed dc grids, in order to prevent individual line power capacity limits restricting overall power flow in the grid. Direct current circuit breakers (DCCBs) will be also required to protect HVDC grids from dc faults. This paper demonstrates that the current flow controller functionality can be added into a hybrid CB's design. This paper proposes integrating an interline CFC into the load commutation switch (LCS) of a hybrid DCCB. The integrated design LCS/CFC is analyzed and a state-space model is derived. The control of the CFC is designed and the performance of the LCS/CFC during normal operation is verified by means of MATLAB Simulink and PSCAD simulations. A comparison of the integrated LCS/CFC and the separate design is given. The case studies show a reduction in total power losses, and improved protection operation times can be achieved. [ABSTRACT FROM PUBLISHER]

High voltage direct current (HVDC) grids may be protected from dc faults through the application of HVDC circuit breakers. Recent advances in dc circuit breaker technologies may allow faults in the dc grid to be cleared without a permanent loss of power to the connected ac grids. The requirements for the protection have yet to be fully defined; especially where half-bridge modular multilevel converter (MMC) controls are concerned. This paper investigates integrating dc circuit breakers with half-bridge MMC converters, specifically looking to at how to recover from a pole-to-pole fault. The fault response of the converter to a fault is analyzed in depth. This analysis highlights key stages in the converter response to a dc fault, allowing the MMC fault currents to be predicted. This analysis is then verified in PSCAD simulations and the power flow recovery is shown. The converter controls are investigated, improvements made to the power flow recovery, and the need for arm current controllers highlighted. [ABSTRACT FROM PUBLISHER]

The use of VSC-HVDC grids for offshore wind farm integration will require the use of dc breaker systems and presently they require dc reactors to limit the rate of rise of fault current. The introduction of large dc reactors throughout a VSC-HVDC system can have a significant impact on its stable operation and will require additional control. This paper analyzes this problem and proposes a PSS-like control (DCPSS) to aid dc grid stability and cope with this effect. A generalized analytical model for studies on dc voltage control is presented. Key stability and transient performance issues caused by the use of the dc reactors in a multiterminal system are investigated by analyzing poles, zeros, and frequency responses of open-loop and closed-loop models. Design and location identification methods for the DCPSS are provided. An excellent damping enhancement is achieved by this controller. The analytical studies and time-domain simulations in this paper are performed based on two VSC-HVDC models. [ABSTRACT FROM AUTHOR]