Search

In this work a stacked winding thin film magnetic core microinductor is proposed to improve the ratio of inductance to dc resistance (DCR). This article also describes an improved ac winding loss model accounting for the asymmetric 2-D magnetic fields present within the device. Two six-turn single layer and stacked winding devices are fabricated, and small signal measurements are presented with dc inductance of 150 nH and DCR of $0.35~\Omega $ for the stacked winding inductor, and with DCR of $0.47~\Omega $ for the single winding inductor. In this case, the total DCR of stacked winding inductor is reduced by approximately 25% compared with the corresponding single layer structure with an equivalent inductance and device area. [ABSTRACT FROM AUTHOR]

Microfabricated inductors experience increasing interest and research activity because of their high potential in buck converters for power supply in package and power supply on chip applications. This paper details the modeling and optimization of microfabricated racetrack inductors. The analytical expressions derived characterize inductance, efficiency, and power density based on geometrical parameters, inductor current, and switching frequency. An accurate analysis of the inductor current that includes the impact of losses is performed to determine the switching frequency, the ac copper losses, and the core losses. The presented model is compared to finite element method simulations and reported results of three microfabricated inductors. Finally, the optimum tradeoff between efficiency and power density is identified using the Pareto front, which results from the evaluation of a large number of microfabricated inductors in the design space defined by the application. [ABSTRACT FROM AUTHOR]

What is the future of integrated inductor design on silicon for power conversion applications at frequencies up to 100 MHz—is it magnetic-core or air-core inductors. This study presents measured results for two microfabricated inductors (magnetic core and air core), which have been designed to operate at 20 MHz and occupy a substrate area of less than 10 mm^2. The inductor technology and design are briefly discussed. An optimized inductor design study is, then, presented. Both magnetic-core and air-core inductor designs are compared and evaluated, in terms of inductance and efficiency per unit area for frequencies up to 100 MHz. The design of the microinductors is discussed and an analytical design optimization program is used to model the devices for the maximum efficiency and inductance. The introduction of laminations with high-frequency core inductors will also be examined within the study. A 100 MHz magnetic-core inductor design with three laminations gives a 36 nH inductance, with 96.4% efficiency and an area of 3 mm^2. A comparable air-core design also gives a 36 nH inductance, with 93.45% efficiency and an area of just 2.6 mm^2. [ABSTRACT FROM AUTHOR]