Search

Multi-machine single-inverter induction motor drives are attractive in situations in which all machines are of similar ratings and operate at approximately the same load torques. The advantages include their small size compared to multi-machine multi-inverter systems, lower weight, and overall cost. This article presents a consolidated study and comparison of vector control methods applied to multi-machine drives along with relevant simulation and experimental results. The mean control method and its modifications prove to be superior to the other control approaches. [ABSTRACT FROM AUTHOR]

Generation is shifting from a centralized power generating facility having large synchronous generators to distributed generation involving sources of smaller capacity. Most of these sources require inverters on the front end while being connected to the grid. Lower available kinetic energy, coupled with less short-circuit current ratio compared to large synchronous generators, compromises the transient stability of the microgrid when isolated from the main grid. Sources in the microgrid use droop control to share power according to their capacity without any form of communication. This paper proposes a novel controller for inverters to improve the frequency response of microgrid under disturbances involving large frequency deviations. It also discusses design of various parameters defined for the proposed control. The microgrid, which has two inverters and two synchronous generators, is simulated using Simulink/MATLAB software to test the proposed control strategy. [ABSTRACT FROM PUBLISHER]

This paper studies microgrids where loads are supplied by parallel-connected inverters controlled by decentralized active power/voltage frequency and reactive power-/voltage-magnitude droop control laws. A paralleled ac system, such as a multiinverter microgrid, is susceptible to circulating currents due to differences in voltage magnitude, frequency, phase angle, or dc offset. Circulating currents due to differences in voltage magnitude and dc offset have been known issues reported in literature. However, an in-depth analysis of the problem is required to ascertain the deviation of the system-operating condition from the desired condition. This paper provides a mathematical model that predicts the effect of voltage-magnitude offsets on reactive power sharing between inverters. Simulation and experimental results verify the accuracy of the analytical results obtained from the mathematical model. We examine the effect of dc-circulating currents and propose a simple capacitor emulation control law implemented in software to eliminate dc-circulating currents. This solution is a possible alternative for hardware implementation to eliminate dc-circulating currents. The effectiveness of the capacitor emulation control law has been verified through experimental results. [ABSTRACT FROM PUBLISHER]

The time integral of the output voltage vector of a three-phase inverter is often termed the inverter flux vector. This paper addresses the control of a three-phase four-leg sine-wave output inverter having an LC filter at its output, by controlling the flux vector in three dimensions. Flux vector control has the property that an output filter resonance is actively damped by an output voltage control loop alone. Furthermore, an inverter switching action inherently regulates the output voltage rapidly against dc-bus voltage variations. The flux vector control of sine-wave output inverters finds several applications in three-phase four-wire systems. This paper presents a flux modulation method for threephase four-leg inverters feeding unbalanced and nonlinear loads. All the necessary steps for the digital implementation of the flux modulator are presented. The switching behavior of the modulator has been evaluated, which is useful for the variable fundamental frequency applications of the inverters. To provide experimental validation, the modulator is implemented as a part of the control system for a stand-alone three-phase four-leg inverter with an LC filter at its output. Control system details are also provided. Experimental results indicate the effectiveness of the modulator and control system in providing balanced voltages at the output of the LC filter even under highly unbalanced conditions with nonlinear loads. The resonance damping and voltage regulation properties of the modulator are also apparent from the experimental results. [ABSTRACT FROM AUTHOR]