Search

This paper presents different state feedback approaches of finite control set model predictive control (FCS-MPC) applied to a grid-connected voltage-source converter (VSC) with an LCL filter. Besides converter-side current feedback, two multivariable control approaches and line-side current control are introduced and compared based on theoretical and experimental evaluation. As the LCL filter introduces an additional resonance frequency to the system, the use of different active damping (AD) methods in combination with FCS-MPC is discussed. Furthermore, practical control implementation issues are discussed. The presented methods reveal the great potential, high dynamic performance, and flexibility of FCS-MPC, enabling multivariable control as well as both reduced switching losses and low harmonic current distortion at the same time. Eventually, the feasibility of the theoretical control concepts is shown in a laboratory environment. [ABSTRACT FROM AUTHOR]

Pulsewidth modulation (PWM) voltage source converters are becoming a popular interface to the power grid for many applications. Hence, issues related to the reduction of PWM harmonics injection in the power grid are becoming more relevant. The use of high-order filters like LCL filters is a standard solution to provide the proper attenuation of PWM carrier and sideband voltage harmonics. However, those grid filters introduce potentially unstable dynamics that should be properly damped either passively or actively. The second solution suffers from control and system complexity (a high number of sensors and a high-order controller), even if it is more attractive due to the absence of losses in the damping resistors and due to its flexibility. An interesting and straightforward active damping solution consists in plugging in, in cascade to the main controller, a filter that should damp the unstable dynamics. No more sensors are needed, but there are open issues such as preserving the bandwidth, robustness, and limited complexity. This paper provides a systematic approach to the design of filter-based active damping methods. The tuning procedures, performance, robustness, and limitations of the different solutions are discussed with theoretical analysis, selected simulation, and experimental results. [ABSTRACT FROM PUBLISHER]

Fault tolerance is gaining growing interest to in- crease the reliability and availability of distributed energy sources. Current sensor fault detection, isolation, and reconfiguration are presented for a voltage-oriented controlled doubly fed induction generator, which is mainly used in wind turbines. The focus of this analysis is on the isolation of the faulty sensor and the actual reconfiguration. During a short period of open-loop operation, the fault is isolated by looking at residuals calculated from observed and measured signals. Then, replacement signals from observers are used to reconfigure the drive and reenter closed-loop control. Laboratory measurement results are included to prove that the proposed concept leads to good results. [ABSTRACT FROM AUTHOR]

Fault tolerance is gaining interest as a means to in- crease the reliability and availability of distributed energy systems. In this paper, a voltage-oriented doubly fed induction generator, which is often used in wind turbines, is examined. Furthermore, current, voltage, and position sensor fault detection, isolation, and reconfiguration are presented. Machine operation is not interrupted. A bank of observers provides residuals for fault detection and replacement signals for the reconfiguration. Control is temporarily switched from closed loop into open-loop to decouple the drive from faulty sensor readings. During a short period of open-loop operation, the fault is isolated using parity equations. Replacement signals from observers are used to reconfigure the drive and reenter closed-loop control. There are no large transients in the current. Measurement results and stability analysis show good results. [ABSTRACT FROM AUTHOR]