Search

Voltage multiplier factor circuits area unit wide employed in several high-voltage/low-current applications this paper proposes a hybrid SVM (HSVM) for dc high-voltage applications. The multiplier factor is made by cascading a diode-bridge rectifier associated an (symmetrical voltage multiplier factor) SVM with diode-bridge rectifier because the initial stage of multiplier. The planned topology saves 2 high-voltage capacitors and needs just one secondary of HVT. Besides, it's lesser free fall and quicker transient response at start-up, compared with typical SVM. [ABSTRACT FROM AUTHOR]

during this paper a completely unique topology for top increase DCDC convertor is introduced. The convertor makes use of coupled electrical device and voltage multiplier factor cell to achieve the specified high increase voltage gain. the most benefits of the projected convertor square measure easy topology, high increase voltage gain, continuous input current, exercise the energy of the run inductance of the coupled electrical device, and utilizing only 1 active switch with reduced voltage stress. Reduced switch voltage stress leads to choice of switch with low on-resistance that improves the potency. Operational principles of the convertor in steady state square measure studied Associate in Nursingd an analytical approach is employed to realize voltage gain and switch voltage stress. [ABSTRACT FROM AUTHOR]

This paper presents a very distinctive boost device with twin coupled-inductors and a voltage variety module. On the one hand, the primary windings of two coupled-inductors unit of measurement connected in parallel to share the input current and deate this ripple at the input. On the other hand, the projected device inherits the deserves of interleaved series-connected output capacitors for prime voltage gain, low output voltage ripple and low switch voltage stress. Moreover, the secondary sides of two coupled-inductors unit of measurement connected asynchronous to a regenerative device by a diode for extending the voltage gain and leveling the primary-parallel currents. In addition, the active switches unit of measurement turned on at zero-current and conjointly the reverse recovery disadvantage of diodes is relieved by low cost leak inductances of the coupled inductors. Besides, the energy of leak inductances is recycled. [ABSTRACT FROM AUTHOR]

The increased asset utilization, facilitates the penetration of renewable sources and improves the exibility, reliability and efficiency of the grid, Separate Energy Storage Devices (SESD) technology has been progressed. SESD Technology has the potential to bring real power storage characteristic to protect consumer's loads from the grid voltage uctuations like Long and Short term Voltage variation conditions. This project deals the Design of Decision making Switch and operation principle of the SESD based Dynamic Voltage Restorer (DVR) and its design is based on simple PI control method to compensate voltage Fluctuations. The principle of SESD based DVR is analyzed in this work. The performance of the SESD is validated through simulations using MATLAB SIMULINK and the results reveals that the SESD can be a useful DC source for the DVR. [ABSTRACT FROM AUTHOR]