Search

Owing to the strong penetration ability of X-rays and the imaging visibility, X-ray inspection has been gradually applied to power grids. However, various problems occur in the promotion and application of X-ray inspection in ultra high voltage gas-insulated switchgear (UHV GIS) owing to its large size. These problems relate to parameter selection, photography, protection area, random defect recognition, and risk assessment based on the X-ray image. In this paper, an X-ray digital imaging system is set up for UHV GIS inspection. Parameter selection for UHV GIS is discussed, and we demonstrate that UHV GIS can be photographed under a source-to-detector distance (SDD) of 2.8 m, a tube voltage of 300 kV, and an exposure of >240 mA·s. A photographic method for UHV GIS, entailing adjustment of the position of the imaging plate with a fixed position of the X-ray generator, is proposed to reduce the difficulty in image stitching. The influence of the parameters on imaging quality is discussed, and we show that the brightness and contrast increase with increasing exposure or decreasing SDD. The interactions between parameters are qualitatively introduced. Moreover, the sensitivity of X-ray inspection in UHV GIS is studied under selected parameters, and the sensitivity of X-ray inspection to copper particles and aluminum particles in UHV GIS are shown to be <0.7 mm and <1.1 mm, respectively. Radiation protection for operators is also discussed. In addition, a pseudo-color scheme for identifying random tiny defects is proposed to reduce human error. Finally, the risk level of defects with X-ray inspection is defined by size feature. [ABSTRACT FROM AUTHOR]

The on-site measurement of transient voltages is of great significance in analyzing the fault cause of power systems and optimizing the insulation coordination of power equipment. Conventional voltage transformers normally have a narrow bandwidth and are unable to accurately measure various transient voltages in power systems. In this paper, a wideband parallel resistive–capacitive voltage divider is developed, which can be used for online monitoring of transient voltages in a 220 kV power grid. The structures of the high-voltage and low-voltage arms were designed. The internal electric field distribution of the high-voltage arm was analyzed. The influence factors and improvement techniques of the upper frequency limit were studied. The parameters of the elements of the divider were determined. The voltage withstand performances and scale factors under lightning impulses and AC and DC voltages, the temperature stabilities of scale factors and the step response and bandwidth of the developed voltage divider were tested. The results show that the deviations of the scale factors under various voltage waveforms and different temperatures ranging from −20 to 40 °C are within 3%. The withstand voltage meets the relevant requirements specified in IEC60071-1-2011. The step response 10~90% rise time is approximately 29 ns, and the 3 dB bandwidth covers the range of DC to 10 MHz. [ABSTRACT FROM AUTHOR]