Search

The generation of high-power electromagnetic waves is one of the major applications in the field of highintensity pulsed power. The conventional structure of a pulsed power generator contains a primary energy source and a load separated by a power-amplification system. The latter performs time compression of the slow input energy pulse and delivers a high-intensity power output to the load. Usually, either a Marx generator or a Tesla transformer is used as a power amplifier. In the present case, a system termed "module oscillant utilisant une nouvelle architecture" (MOUNA) uses an innovative and very compact resonant pulsed transformer to drive a dipole antenna. This paper describes the ultracompact multiprimary winding pulsed transformer developed in common by the Université de Pau and Hi Pulse Company that can generate voltage pulses of up to 0.6 MV, with a rise time of less than 270 ns. The transformer design has four primary windings, with two secondary windings in parallel, and a Metglas 2605SA1 amorphous iron magnetic core with an innovative biconic geometry used to optimize the leakage inductance. The overall unit has a weight of 6 kg and a volume of only 3.4 L, and this paper presents in detail its design procedure, with each of the main characteristics being separately analyzed. In particular, simple but accurate analytical calculations of both the leakage inductance and the stray capacitance between the primary and secondary windings are presented and successfully compared with CST-based results. Phenomena such as the core losses and saturation induction are also analyzed. The resonant power-amplifier output characteristics are experimentally studied when attached to a compact capacitive load, coupled to a capacitive voltage probe developed jointly with Loughborough University. Finally, an LTspice-based model of the power ampli- fier is introduced and its predictions are compared with results obtained from a thorough experimental study. [ABSTRACT FROM AUTHOR]

A number of high-power applications require a transportable high-energy, high-current GW generator to drive a pulsed power system at the output. A first prototype, based on exploding wire technology and using an H-bridge circuit configuration, was developed at Loughborough University a few years ago and has been previously reported. The present stage of the work has necessitated the development of a more powerful and energetic source, and this is now based on inductive storage technology. A 400 kJ capacitor bank is connected by a high-Coulomb explosively driven closing switch with an air-cored 0.6 MV transformer, an exploding wire array, and a high-power diode based on a polarity-dependent spark-gap completing the arrangement. The GW generator, including the command and control module, is accommodated in two ISO containers. The various components of the generator are described in this paper, together with results obtained from full-scale tests. [ABSTRACT FROM PUBLISHER]

SPHINX is a microsecond linear transformer driver located at Atomic Energy Comission (CEA) Gramat (France), which can deliver a current pulse of 6 MA within 800 ns in a Z -pinch load. Using the concept of the dynamic load current multiplier (DLCM), which was proposed by Chuvatin, we expect to increase the load current above 6 MA, while decreasing its rise time to \sim300 ns. The DLCM developed by the CEA Gramat and International Technologies for High Pulsed Power (ITHPP) is a compact system made up of concentric electrodes (autotransformer), a dynamic flux extruder (cylindrical wire array), a vacuum convolute (eight post-hole rods), and a closing switch (compact vacuum surface switch). The latter is a key component of the system, which is used to prevent the current from flowing into the load until the inductance builds up due to the implosion of the wire array. This paper presents the design and testing of the DLCM surface switch, resulting from both electrostatic simulations and experiments on the SPHINX generator. These studies, carried out either with or without load (open circuit), were valuable for a first experimental evaluation of the DLCM scheme in a microsecond regime and provided detailed information on the surface switch behavior. [ABSTRACT FROM AUTHOR]