Search

Automotive point-of-load dc–dc converters have a wide input voltage range from 4.5 to 42 V and, in order to avoid the AM band interference and comply with the strict CISPR-25 standard for electromagnetic interference (EMI) performance, the switching frequency is desired to be higher than 2 MHz. Buck converter is currently employed for such applications owing to its simplicity and low cost, but it has low efficiency at high switching frequencies and high EMI noise emission due to hard switching. A new active-clamp buck converter is proposed in this paper, which features zero-voltage-switching for main and auxiliary switches, and soft turnoff for synchronous rectifier over a wide input voltage range. The detailed operating principle analysis and several important design considerations are presented. Extensive design equations that can be adapted for other specifications and applications are also derived. A 2.2 MHz, 5V/5A prototype converter with only Silicon mosfets has been designed, built, and tested. The experimental results verify the converter operation and demonstrate the superior performance of the proposed active-clamp buck converter. [ABSTRACT FROM PUBLISHER]

This paper proposes a new high-gain soft-switching dc–dc topology based on a switched inductor boost converter (SIBC). A conventional SIBC as a high gain boost topology has the issues of high conduction loss in switching diodes and high switching loss in the main switches. Also, it has severe electromagnetic interference (EMI) issue due to high-frequency ringing formed by parasitic inductance and diode junction capacitors. The new topology is derived with the objective of achieving zero voltage switching (ZVS) turn on of the main switch. Instead of adding extra active clamp zero voltage transition (ZVT) path at the switching node, the proposed topology augments the auxiliary ZVT path to the switching diode path. This is achieved by replacing the switching diodes with synchronous switches. The new topology can achieve soft switching for all the switches and alleviate the EMI issue. All the diodes achieve zero current switching (ZCS) turn off without reverse recovery. Auxiliary switches have ZCS turn on and ZVS turn off, and the main switches have ZVS turn on. The soft-switching SIBC also reduces the conduction loss in the switching diodes. A numerical simulation in PLECS and a prototype hardware are built corresponding to a micro-inverter application with 100 kHz switching frequency. Peak power conversion efficiency of 94.76% is achieved in the hardware prototype with Si devices. [ABSTRACT FROM PUBLISHER]