Search

Multispeed transmissions are helpful for improvement of the economy and drivability of electric vehicles (EVs). In this paper, we propose a two-speed transmission based on dual planetary gear mechanism, in which shifts are realized by torque transfer between two brakes located on ring gears. To synthesize the dynamic and economic performances of the vehicle, a multiobjective optimization problem is constructed for gear ratio optimization and Pareto-optimal solutions of gear ratio combinations are obtained by Nondominated sorting genetic algorithm-II (NSGA-II). In particular, the minimum electric energy consumption of the EV is calculated with a fast Dynamic Programming (DP) in each iteration. Following this, a constant-output-torque control (COTC) scheme is adopted for the torque phase and inertia phase of gearshift process to ensure constant output torque on the wheel. To enhance transient responses, the feedforward–feedback controller structure is applied and a disturbance observer is integrated to improve robustness. Simulation results demonstrate that the two-speed transmission has much better performance in terms of acceleration time and energy economy compared to the fixed-ratio transmission, and the proposed gearshift control method is able to achieve fast and smooth gear shift robustly while maintaining constant output torque. [ABSTRACT FROM AUTHOR]

This paper presents the mathematical modeling and analysis of a novel multimode transmission (MMT) for a hybrid electric vehicle (HEV) using a single electric machine (EM), which implies compactness and low cost. The single-EM solution avoids losses from another EM and its power electronics, which are employed in many existing HEVs. The topology of the MMT planetary gearset is the same as that of conventional four-speed automatic transmissions (ATs). The MMT realizes five power flow modes, which are developed into 16 operation modes, including one Motor_only mode, four Engine_only modes, four Compound driving modes, six Braking modes, and one Charging while parking mode. The properly arranged clutches transmit power flow more flexibly, allow direct mechanical power transmission from the engine to the drive shaft, and avoid spin loss for the engine and energy conversion loss for the electric components. Simulation under the New European Driving Cycle (NEDC) shows that the fuel consumption of the proposed HEV is comparable to a benchmark “THS II-like” vehicle, which uses a planetary gearset, two EMs, and no clutch, which indicates the fuel economy potential of this concept. [ABSTRACT FROM PUBLISHER]

Abstract: This paper presents a powertrain control strategy for a series hybrid electric vehicle (SHEV) based on the integrated design of an active charging scenario and fixed-boundary-layer sliding mode controllers (FBLSMCs). An optimized charging curve for the battery is predetermined rather than subject to engine output and vehicle power demand, which is a total inverse of normal SHEV powertrain control process. This is aimed to remove surge and high-frequency charge current, keep the battery staying in a high state-of-charge (SOC) region and avoid persistently-high charge power, which are positive factors to battery lifetime extension. Then two robust chattering-free FBLSMCs are designed to locate the engine operation in the optimal efficiency area. One is in charge of engine speed control, and the other is for engine/generator torque control. Consequently, not only fuel economy is improved but also battery life expectancy could be extended. Finally, simulation and experimental results confirm the validity and application feasibility of the proposed strategy. [Copyright &y& Elsevier]

Abstract: Hybrid electric buses have been a promising technology to dramatically lower fuel consumption and carbon dioxide (CO2) emission, while energy management strategy (EMS) is a critical technology to the improvements in fuel economy for hybrid electric vehicles (HEVs). In this paper, a suboptimal EMS is developed for the real-time control of a series–parallel hybrid electric bus. It is then investigated and verified in a hardware-in-the-loop (HIL) simulation system constructed on PT-LABCAR, a commercial real-time simulator. First, an optimal EMS is obtained via iterative dynamic programming (IDP) by defining a cost function over a specific drive cycle to minimize fuel consumption, as well as to achieve zero battery state-of-charge (SOC) change and to avoid frequent clutch operation. The IDP method can lower the computational burden and improve the accuracy. Second, the suboptimal EMS for real-time control is developed by constructing an Elman neural network (NN) based on the aforementioned optimal EMS, so the real-time suboptimal EMS can be used in the vehicle control unit (VCU) of the hybrid bus. The real VCU is investigated and verified utilizing a HIL simulator in a virtual forward-facing HEV environment consisting of vehicle, driver and driving environment. The simulation results demonstrate that the proposed real-time suboptimal EMS by the neural network can coordinate the overall hybrid powertrain of the hybrid bus to optimize fuel economy over different drive cycles, and the given drive cycles can be tracked while sustaining the battery SOC level. [Copyright &y& Elsevier]

This paper aims to present a new type of series–parallel hybrid electric bus and its energy management strategy. This hybrid bus is a post-transmission coupled system employing a novel transmission as the series–parallel configuration switcher. In this paper, the vehicle architecture, transmission scheme and numerical models are presented. The energy management system governs the mode switching between the series mode and the parallel mode as well as the instantaneous power distribution. In this work, two separated controllers using fuzzy logic called Mode Decision and Parallel-driving Energy Management are employed to fulfill these two tasks. The energy management strategy and the applications of fuzzy logic are described. The strategy is validated by a forward-facing simulation program based on the software Matlab/Simulink. The results show that the energy management strategy is effective to control the engine operating in a high-efficiency region as well as to sustain the battery charge state while satisfy the drive ability. The energy consumption is theoretically reduced by 30.3% to that of the conventional bus under transit bus driving cycle. In addition, works need future study are also presented. [Copyright &y& Elsevier]