Search

Highlights: [•] A purge-and-trap method was developed using a novel extraction needle. [•] The needle has multi-bed-type sorbent for extraction of VOCs in water sample. [•] The sampling time of the method was approximately 9min. [•] The method was successfully applied for the analysis of real tap water samples. [ABSTRACT FROM AUTHOR]

Abstract: A novel needle-type sample preparation device was developed for the effective preconcentration of volatile organic compounds (VOCs) in indoor air before gas chromatography–mass spectrometry (GC–MS) analysis. To develop a device for extracting a wide range of VOCs typically found in indoor air, several types of particulate sorbents were tested as the extraction medium in the needle-type extraction device. To determine the content of these VOCs, air samples were collected for 30min with the packed sorbent(s) in the extraction needle, and the extracted VOCs were thermally desorbed in a GC injection port by the direct insertion of the needle. A double-bed sorbent consisting of a needle packed with divinylbenzene and activated carbon particles exhibited excellent extraction and desorption performance and adequate extraction capacity for all the investigated VOCs. The results also clearly demonstrated that the proposed sample preparation method is a more rapid, simpler extraction/desorption technique than traditional sample preparation methods. [Copyright &y& Elsevier]

Abstract: A new approach to the determination of human breath acetone with particle-packed sample preparation needle was developed. The extraction needle was packed with a copolymer of methacrylic acid and ethylene glycol dimethacrylate as the extraction medium. For the analysis of breath sample, exhaled breath was collected in a sampling bag, and 50mL of the breath sample was extracted with the needle-type sample preparation device followed by analysis using gas chromatography–mass spectrometry (GC–MS). After the optimization of several basic extraction conditions for standard acetone samples, breath acetone concentration taken from controlled type-2 diabetic patients was determined. Furthermore, time variations of breath and urine acetone of four healthy individuals under fasting conditions were measured. Urine sample was collected in glass vial, and urine acetone concentration was also determined with the extraction needle by analyzing the corresponding headspace gas. The results demonstrated that the particle-packed extraction needle showed an excellent extraction performance for acetone in both breath and urine headspace samples, and that there is a clear correlation between the concentration of breath acetone and HbA1c level of controlled type-2 diabetic patients. The breath acetone level in controlled diabetic patients was in the range between 0.19 and 0.66ppmv, where its concentration in medically untreated type-2 patient was 0.92 and 1.20ppmv. The breath acetone concentration in healthy male was increased to 5.66ppmv under the 24h of fasting test, and a high correlation between the breath and urine acetone concentration was also observed. On the basis of the above results, the potential applications of the proposed method to the diagnosis of diabetes and/or ketoacidosis were suggested. [Copyright &y& Elsevier]

Abstract: Fiber-packed sample preparation device was applied to the simultaneous derivatization/preconcentration of ethylene oxide (EO) in air samples. The polymer-coated filaments were packed longitudinally into the needle, and hydrogen bromide (HBr) was loaded onto the filaments in the preconditioning process. Simultaneous derivatization with HBr in the needle was made during the sampling process of the gaseous EO, and the corresponding derivatized analyte, 2-bromoethanol, was desorbed by passing a small amount of methanol through the extraction needle in the heated gas chromatograph (GC) injector. The basic extraction/desorption parameters for EO have been evaluated. The limit of detection (LOD), limit of quantification (LOQ) and the relative standard deviation (RSD) of run-to-run repeatability were 1.8ng/L, 5.4ng/L and less than 4%, respectively, with an extraction time of about 10min. Satisfactory storage performance for three days at room temperature was also confirmed. [Copyright &y& Elsevier]

Abstract: For two-dimensional reversed-phase liquid chromatography–gas chromatography (2D RPLC–GC), a specially-designed needle packed with a polymer-coated fibrous stationary phase was introduced as a novel interface. The bundle of synthetic fibers coated with polydimethylsiloxane (PDMS) was packed into the head section of the needle, and served as the extraction medium. Using the post-column dilution of the LC eluent by water and subsequent extraction with the needle interface, the analyte was successfully concentrated to the PDMS phase on the fibrous support in the needle. The concentrated analytes were directly injected to GC system by inserting the needle to a heated GC injector. 2D separations of aliphatic and aromatic hydrocarbons, and also kerosene-extract were performed with the off-line RPLC–GC system interfaced by the needle extractor. The results suggested that the fiber-packed needle interface could be one of the simple and effective approaches to develop an on-line coupled LC–GC system. [Copyright &y& Elsevier]

Abstract: We review the approach to miniaturization of sample preparation using a fiber-packed capillary as the medium, especially for on-line coupling of the processes of sample preparation and chromatographic separation. We summarize our novel use of polymeric fiber filaments as the extraction medium for microscale liquid-phase and gas-phase separations that we have developed. [Copyright &y& Elsevier]