Search

A constant worldwide growing load stress over a power system compelled the practice of a reactive power injection to ensure an efficient power network. For this purpose, multiple technologies exist in the knowledge market out of which this paper emphasizes the usage of the flexible alternating current transmission system (FACTS) and presents a comparative study of the static var compensator (SVC) with the static synchronous compensator (STATCOM), inducted in a real electric substation. The aim is to improve the power factor (PF) and power quality and to encounter reliably extreme conditions. A 220 kV electric substation was opted for the analysis, and both the static and dynamic conditions were observed with the help of a power system analysis tool termed PowerFactory-DIgSILENT. Multiple aspects were investigated via software simulations to assess the performance of the aforementioned FACTS devices, such as the voltage profile evaluation via the load flow analysis method (LFA), the harmonic response via the power quality and harmonic analysis tool, and the short-circuit response via the RMS simulation tool. The outcomes were verified and compared with permissible values included in the universal standards, such as IEC and IEEE. The superiority of the STATCOM over the SVC was proven in light of the simulative results. [ABSTRACT FROM AUTHOR]

In order to increase the power transfer and providing the optimum utilisation of the power system capability, application of flexible alternating current transmission system (FACTS) devices technology, such as static synchronous compensator (STATCOM), has been attracted, in recent years. However, the STATCOM changes the voltage and current of the power system that disturb the operation of the impedance‐based synchronous generator loss of excitation (LOE) protection. Then, this study proposes a new flux‐based LOE protection method, in the presence of STATCOM, that is based on the local variation of the flux linkage of the generator available at the location of relay. The mentioned relay is independent of other generator protection relays without any coordination. In order to show the satisfying operation of the proposed method, some simulations have been carried out in the Matlab/Simulink software. A single‐machine infinite bus and a three‐machine infinite bus systems have been used in simulations. The results show that the presence of STATCOM has no important effect on the performance of proposed relay opposite to a negative offset relay with two protective zones (the widely used impedance method) which is affected by STATCOM operation. [ABSTRACT FROM AUTHOR]

STATCOM is a FACTS controller that is used in power systems to regulate the line voltage, enhance the power transmission capacity and extend the transient stability margin. STATCOM is conventionally realized by a voltage-source converter; however, being a current injection device, its performance can be improved when realized by a current-source converter (CSC) that can generate a controllable current directly at its output terminals. In this paper, a STATCOM based on the current-source converter topology is proposed. The nonlinear model of the current-source converter, which is the source of the difficulties in the controller design, has been modified to a linear model through a novel modeling technique. The proposed modeling technique is not based on the linearization of a set of nonlinear equations around an operating point. Instead, the power balance equation and a nonlinear input transformation are used to derive a linear model independent of the operating point. This model acts as the basis for the design of a decoupled state-feedback controller. The proposed STATCOM has been simulated using the PSCAD/EMTDC package. The simulation results show that a CSC-based STATCOM can result in excellent current and voltage waveforms as well as very short response time while operating at a low switching frequency. This makes the proposed scheme suitable for high power applications. [ABSTRACT FROM PUBLISHER]